CONDUIT 2926812 - Caterpillar

Table 1
Required Tools    
Part Number     Description     Quantity    
198-4240     Digital Pressure Indicator     1    
Personal injury or death can result from escaping fluid under pressure.Escaping fluid under pressure, even a very small pin-hole size leak, can penetrate body tissue and cause serious injury and possible death. If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.Always use a board or cardboard when checking for a leak.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Ensure that the hydraulic oil in the system is at normal operating temperature. Park the machine on a level surface.
Illustration 1 g01936539
Parking Brake Switch
Place the parking brake switch in the ON position. The ladder will lower. Ensure that all personnel are clear of the ladder before you lower the ladder.
Stop the engine.
Illustration 2 g01936615
Steering Frame Lock (LOCKED Position)
Install the steering frame lock with the two pins. Place blocks in front of the wheels and behind the wheels.
Illustration 3 g01944830
Location of the Implement Pump under Cab
Raise the cab in order to gain access to the implement piston pump and the control valve.
Illustration 4 g01944831
View of the manifold for the implement pump (1) Pressure tap for signal pressure of piston pump (implement). (2) Piston pump (implement). (3) Manifold (piston pump)(implement). (4) Hydrostatic piston pump
Install a 198-4240 Digital Pressure Indicator on pressure tap (1). Pressure tap (1) is located at the "GP2" port of the manifold for the implement pump.Note: Hydraulic pressure can be viewed with IQAN on the display for hydraulic pressure.
Start the engine. The pressure should be 1503 kPa (218 psi). Stop the engine. If the standby pressure is not adjusted to the correct pressure setting, perform Steps 8 through 11.
Start the engine.
Illustration 5 g01945406
Activate the pilot switch.
Illustration 6 g01945140
View of the Piston Pump (Implement) (5) Locknut. (6) Adjustment screw
Loosen locknut (5). Turn adjusting screw (6) until the pressure gauge indicates 1503 kPa (218 psi).
Tighten locknut (5) .
Stop the engine.
Remove the test equipment.