CONE-SPECIAL TAPERED 1194139 - Caterpillar

Test Procedure
To prevent injury or death, never work under a machine while a test is being performed.
Clear all personnel from the machine and from the area around the machine.
Start the engine.
Illustration 8 g02446738
Power mode control button located on the soft panel switch
Push down on the power mode control button in order to activate power mode.Note: The indicator light will be illuminated when power mode is activated.
Illustration 9 g02447036
Automatic Engine Speed Control (AESC) as displayed on the programmable function key in the monitor.
Disable the automatic engine speed control through the monitor by pressing the programmable button.
Illustration 10 g03722432
Hydraulic modulation switch on left joystick
Illustration 11 g06174873
Hydraulic modulation medium mode (monitor display)
Select the hydraulic modulation mode as medium. Press the lower front switch on the left joystick to select the hydraulic modulation mode.
The air conditioning should be turned off for the following test.
Clear all personnel from the machine and from the area around the machine.
Illustration 12 g02452604
Engine speed dial
Set the engine speed dial at "1".Note: Do not activate any implements.
Illustration 13 g02453444
Transmission control button located on the soft panel switch
Push down on the transmission control button in order to select SECOND GEAR. Note: The first indicator light will illuminate when the transmission is in SECOND GEAR.
Use the monitor in the cab in order to activate the "Backup Mode".
Illustration 14 g03722433
Press the "Menu" key to display the main menu options.
Illustration 15 g03737238
Press the "Backup" key from the "Main Menu" in order to activate backup mode.
Override the "Travel Pilot Solenoid Current Override" in the step sequence below in order to perform the test procedure.
Start Electronic Technician.
Select the "Machine ECM" from the list of available controls.
From the top menu, select "Diagnostics".
From the pull-down menu, select "Diagnostic Tests".
Then select "Override Parameters".
Select "Travel Motor Swashplate Angle Limit Solenoid Current Override" and adjust the current to 0.9 amp.
Select "Travel Forward Select Solenoid Override" and turn the solenoid to ON.
Select "Travel Pilot Solenoid Current Override" and adjust the current to 0.9 amp.
Lower the left console.
Release the service brake pedal.Note: Do not activate any implements.
Depress the travel speed pedal fully in the FORWARD position.
Slowly turn the adjustment screw on main relief valve (3) counterclockwise until the upstroke pressure at pressure tap (1) is within specifications. Refer to Table 1 for the correct pressure.
Deactivate the backup mode in the monitor.
Fully depress the service brake pedal until the service brake pedal locks mechanically.
Stop the engine.
Raise the left console.
If the upstroke pressure is not set to the proper specification, perform the "Adjustment Procedure" in order to adjust the upstroke pressure.Adjustment Procedure
Note: If the original cap is on the upstroke pressure adjustment screw, do not make any adjustments until the root cause of failure has been verified.
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.
Loosen the locknut on upstroke adjustment screw (2).