CONE 1262728 - Caterpillar

Install solenoid (29). Make sure that the orientation of solenoid (29) is correct. Install nut (28). Tighten nut (28) to a torque of 20 3 N m (177 27 lb in).
Illustration 53 g03573038
Install O-ring seals (26) and O-ring seal (27) to housing assembly (25).
Illustration 54 g03573016
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install housing assembly (25).
Illustration 55 g03572997
Install valve body (24).
Illustration 56 g03572976
Install O-ring seal (23), O-ring seals (22), and O-ring seals (21).
Illustration 57 g03572956
Install plug (20) and the O-ring seal to valve block (4). Install fittings (18) and (19) and the O-ring seals. Make sure that the orientation of fitting (18) is correct.
Illustration 58 g03572936
Install orifice (17).
Illustration 59 g03572916
Install fitting (16) and the O-ring seal. Make sure that the orientation of fitting (18) is correct.
Illustration 60 g03572898
Install O-ring seal (9) to shuttle valve (8). Install O-ring seal (10) and backup ring (11). Install backup ring (14) and O-ring seal (15). Install O-ring seal (12) and backup ring (13).
Illustration 61 g03572896
Install shuttle valve (8). Tighten shuttle valve (8) to a torque of 70 7 N m (52 5 lb ft).
Illustration 62 g03572876
Install O-ring seals (7) and (6) to main relief plug (5).
Illustration 63 g03572859
Install main relief plug (5). Tighten main relief plug (5) to a torque of 65 7 N m (48 5 lb ft).
Illustration 64 g03572816
Install valve block (4).
Illustration 65 g03572796
Install nuts (3). Tighten nuts (3) to a torque of 105 10 N m (77 7 lb ft).
Illustration 66 g03572759
Connect harness assemblies (1). Install bolt (2).End By:
Install the auxiliary control valve.