CONE-SPECIAL TAPERED 1714745 - Caterpillar

Illustration 1 g03383117
Monitor
(1) Action Lamp
(2) Clock
(3) Engine Speed Dial Indicator
(4) Gauges
(5) Camera View
(6) Active Diagnostic View
(7) Keypad
Illustration 1 is the default screen of the monitor. This screen appears when the monitor is initially turned ON.
Illustration 2 g03621418
(8) Keypad guidance area
(9) Back key
(10) OK key
(11) Menu key
(12) Left key
(13) Up key
(14) Down key
(15) Right key
(16) Enter key
Illustration 3 g03578236
Press menu key (11). Illustration 3 will be displayed. Use arrow keys (12), (13), (14), and (15) in order to highlight "SERVICE" menu option.
After the "SERVICE" option is highlighted, press OK key (10).
Illustration 4 g03578257
After OK key (10) is pressed, the above screen will be displayed. The keys for direction are used to input the password. Different passwords allow access to menus that are in the monitor. For more information on the passwords, Refer to Systems Operation, "Monitor Overview" for the Tool Control System. The password that allows access to all menus that are used for service is "9992". Use the directional arrows to input the password. Press OK key (10) in order to enter the highlighted character.
After entering the last number of the password, press Enter key (16) to continue with the "SERVICE" screen.
Illustration 5 g03621937
When the correct password is entered, the "SERVICE" menu will appear.
Illustration 6 g03621976
If an incorrect password is entered, Illustration 6 is displayed.
Press the OK key (10) in order to retry the password. Press the cancel key (7) in order to exit the program. Exiting the Service Mode
Three methods are used in order to terminate the service mode. The service mode will be terminated 10 seconds after the start switch is turned to the OFF position. Use the procedures below if the start switch is not turned to the Off position.
Press back key (9). The monitor will display the previous menu when the cancel key is pressed. Stop when the default screen appears.
Press home key (11). By pressing the home key, the monitor will automatically go to the default screen.