CONE-ROLLER BEARING 1P2662 - Caterpillar

Generator Set: C32 (S/N: RNX1-824)Marine Engine: C32 (S/N: RNY1-2040; RNZ1-1175)Introduction
On certain C32 Marine Engines the primary and the secondary throttle signals are pinned incorrectly on the latest revision to the 368-4961 Diode Gp . This problem only affects engines built without engine mounted control panels.Do not perform any procedure in this Special Instruction until you read this information and you understand this information. Safety Section
Proper installation of electrical components is necessary to prevent component damage. To prevent electrical component damage, turn the engine start switch to the OFF position before connecting or disconnecting electrical components. Failure to follow this procedure may result in electrical component damage.
New Parts Required
Table 1
Quantity     Part Number     Description    
4     126-1767     Connector Pin    
14 cm     9X-1813     Sleeve    
32 cm         16 Gauge Wire-Bulk    Rework Procedure of the 368-4961 Diode Gp to Correctly Wire the Primary and Secondary Throttle Circuits
Illustration 1 g03378957
The primary and secondary throttle circuits are configured incorrectly on the 368-4450 Engine Harness As and the 368-4451 Engine Harness As when used with the 368-4961 Diode Gp (1). In place of an engine mounted control box these affected engines are built with the 368-4961 Diode Gp as shown in Illustration 1.
Illustration 2 g03378962
Note: Engines built with an "On Engine Control Box" (2), as shown in Illustration 2 are not affected and out of scope for this rework procedure.
Illustration 3 g03378966
Cut the bulk wire into two 16 cm (6 inch) lengths (5) and install the four 126-1767 Connector Pins (4) and 9X-1813 Sleeve (3) as shown in Illustration 3.
Illustration 4 g03378967
9X-1343 Connector Receptacle As
Remove the four 8T-8737 Seal Plugs from pins 22, 23, 24, and 25 (6) in the 9X-1343 Connector Receptacle As . The connector receptacle is located on the left side of the engine in the 368-4961 Diode Gp . Refer to Illustrations 1 and 4. Note: Only pins 21 and 25 are numbered in the row.
Illustration 5 g03378968
(7) Pins 23 and 25 (8) Pins 22 and 24
Install the harness to connect the circuits between pins 23 and 25 (7) and pins 22 and 24 (8) as shown in illustration 5.Note: The harness is shown without the sleeve for illustration purposes
Perform a pull-test of 44 N (10 lb) on the end of each wire to ensure that the connector is locked into the receptacle.The primary and secondary throttle circuits are now correctly configured to the Electronic Control Module (ECM).