CONE-BEARING 2125027 - Caterpillar

Ensure that the Safety Information, warnings, and instructions are read and understood before operation or maintenance procedures are performed.To determine the maintenance intervals, use fuel consumption, service hours, or calendar time, which ever occurs first. Engines that operate in severe operating conditions may require more frequent maintenance.Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must also be performed.When Required
Fuel System - Prime
Severe Service Application - Check
Daily
Cooling System Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Clean
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Walk-Around Inspection
Initial 20 to 40 Service Hours
Belt - Inspect
Between 250 Service Hours and 1000 Service Hours
Electronic Unit Injector - Inspect/Adjust
Engine Valve Lash - Inspect/Adjust
Every 6000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change
PM Level 1 - Every 10 400 L (2750 US gal) of Fuel or 250 Service Hours or 6 Months
Air Compressor Filter - Clean/Replace
Alternator - Inspect
Alternator and Fan Belts - Inspect/Adjust/Replace
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Cylinder Head Grounding Stud - Inspect/Clean/Tighten
Engine Air Cleaner Element (Dual Element) - Clean/Replace
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fan Drive Bearing - Lubricate
Fuel System Primary Filter/Water Separator Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Radiator - Clean
PM Level 1 - Every 20 800 L (5500 US gal) of Fuel or 500 Service Hours or 6 Months
Air Compressor Filter - Clean/Replace
Alternator - Inspect
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Cylinder Head Grounding Stud - Inspect/Clean/Tighten
Engine Air Cleaner Element (Dual Element) - Clean/Replace
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fan Drive Bearing - Lubricate
Fuel System Primary Filter/Water Separator Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Radiator - Clean
PM Level 2 - Every 83 250 L (22 000 US gal) of Fuel or 2000 Service Hours or 1 Year
Alternator - Inspect
Engine Crankcase Breather - Clean
Every 208 000 L (55 000 US gal) of Fuel or 5000 Service Hours
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
PM Level 3 - Every 125 000 L (33 000 US gal) of Fuel or 3000 Service Hours or 2 Years
Air Compressor - Inspect
Cooling System Coolant (DEAC) - Change
Cooling System Coolant Extender (ELC) - Add
Cooling System Water Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Mounts - Inspect
Engine Valve Lash - Inspect/Adjust
Engine Valve Rotators - Inspect
Every 380 000 L (100 000 US gal) of Fuel or 10 000 Service Hours
Overhaul Considerations