CONE 2H0930 - Caterpillar

There may be several specific safety messages on your generator set. The exact location and a description of the safety messages are reviewed in this section. Become familiar with all safety messages.Ensure that all the safety messages are legible. Clean the safety messages or replace the safety messages if the words cannot be read or if the illustrations are not visible. Use a cloth, water, and soap to clean the safety messages. Do not use solvents, gasoline, or other harsh chemicals. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the safety messages. The safety messages that are loosened could drop off the engine.Replace any safety message that is damaged or missing. If a safety message is attached to a part of the engine that is replaced, install a new safety message on the replacement part. Your Caterpillar dealer can provide new safety messages.
Do not operate or work on this engine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility.
Illustration 1 g06213157
Illustration 2 g06213144
Illustration 3 g06213194
Illustration 4 g06213186Universal Warning (1)This safety message is on the enclosure for the control panel.
Illustration 5 g01370904
Do not operate or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in serious injury or death.
Automatic Starting (2)This safety message is on the front and sides of the enclosure for the control panel.
Illustration 6 g01392484
When the engine is in the AUTOMATIC mode, the engine can start at any moment. To avoid personal injury, always remain clear of the the engine when the engine is in the AUTOMATIC mode.
Product Link (3)
This safety message is on the roof of the enclosure, near the antenna for the Cat® Product Link™ communication device.
Before applying (installing battery jumper) battery power, note:There are a few countries for which Product Link is not certified. Ensure local radio compliance before operation, see www.Dealer.cat.com/PL/Certification.Use in blast sites is also restricted. Refer to M0075640 for further details.
Illustration 7 g06250090
This equipment is equipped with a Cat® Product Link communication device. When electric detonators are being used for blasting operations, radio frequency devices can cause interference with electric detonators for blasting operations which can result in serious injury or death. The Product Link communication device should be deactivated within the distance mandated under all applicable national or local regulatory requirements. In the absence of any regulatory requirements Caterpillar recommends the end user perform their own risk assessment to determine safe operating distance.
Electrocution (4)
This safety message is on the enclosure for the control panel.
Illustration 8 g01392482
DANGER: Shock/Electrocution Hazard-Do not operate this equipment or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings will result in serious injury or