CONE-ROLLER BEARING 6V0661 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
B     1U-7502     Heavy Duty Repair Stand     1    
C     315-6058     Adapter     1    Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01367512
Install gasket (5) .
Illustration 2 g01367496
Position the transmission charge pump and support (3) to the transmission. Install bolts (2). Install bolts (4). Tighten bolts (4) to a torque of 55 10 N m (41 7 lb ft).
Use Tooling (C) in order to check the rolling torque. The rolling torque should be less than 1 N m (9 lb in).End By:
Install the torque converter housing. Refer to Disassembly and Assembly, "Torque Converter Housing - Install".
If equipped, install the rear PTO shaft. Refer to Disassembly and Assembly, "Pump Drive - Install".