CONE-BEARING 8D1819 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, and filters. The user is also responsible for the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components. Use fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Circuit Breakers - Reset
Fuel System - Prime
Fuel System Primary Filter/Water Separator - Drain
Generator - Dry
Generator Bearing - Lubricate
Generator Set - Test
Generator Set Alignment - Check
Generator Winding - Test
Varistor - Inspect
Every Week
Air Inlet Filter - Inspect/Clean/Test
Battery Charger - Check
Battery Electrolyte Level - Check
Control Panel - Inspect/Test
Coolant Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Fuel Tank Water and Sediment - Drain
Generator - Inspect
Generator Bearing Temperature - Test/Record
Generator Lead - Check
Generator Load - Check
Jacket Water Heater - Check
Power Factor - Check
Standby Generator Set Maintenance Recommendations
Stator Winding Temperature - Test
Voltage and Frequency - Check
Walk-Around Inspection
Every 6 Months
Coolant Sample (Level 1) - Obtain
Every Year
Alternator - Inspect
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 2) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine Crankcase Breather - Clean/Replace
Engine Mounts - Inspect
Engine Oil Sample - Obtain
Engine Protective Devices - Check
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Check
Fuel Injector - Inspect/Adjust
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Generator Bearing - Inspect
Generator Bearing Temperature - Test/Record
Generator Winding Insulation - Test
Hoses and Clamps - Inspect/Replace
Prelube Pump - Inspect
Radiator - Clean
Rotating Rectifier - Check
Starting Motor - Inspect
Stator Lead - Check
Water Pump - Inspect
Every 500 Service Hours or 1 Year
Engine Oil and Filter - Change
Fan Drive Bearing - Lubricate
Every 3 Years
Coolant (DEAC) - Change
Coolant Temperature Regulator - Replace
Turbocharger - Inspect
Every 6 Years
Coolant (ELC) - Change
Every 10 Years
Generator Bearing - Replace
Commissioning
Generator Bearing Temperature - Test/Record
Generator Set Alignment - Check