CONE-ROLLER BEARING 9W5833 - Caterpillar

VIMSTM Event Code List
Table 1 lists the VIMS event codes and recommended responses. Use Cat ET to determine the active or logged event codes.
Table 1
(VIMS ECM Event Codes)    
Event Code    Warning Level    Warning Description    Required Operator Action    
558     1     VIMS Snapshot Stored     Service Soon    
559     1     Event List Memory Low     Download Data    
630     2     Switched Sensor #1 Activated        
631     2     Switched Sensor #2 Activated        
632     2     Switched Sensor #3 Activated        
633     2     Switched Sensor #4 Activated        
861     1     Clock Manual Alignment Required        
861     2     Clock Manual Alignment Required        
1087     1     VIMS Trend Memory Low     Download and Reset Data    
1088     2     VIMS Trend Memory Full     Download and Reset Data    
1189     1     File System Memory Low     Download Soon    
1189     2     File System Memory Full     Download immediately    
1377     1     Machine Disable Pending Due to Machine Security        
1377     2     Machine Disable Pending Due to Machine Security        
2139     1     Snapshot Memory Full        Warnings and Indications
Warnings
The Cat monitoring system will alert the operator when an event code is active. Event codes are activated in one of three warning levels according to the severity of the condition. The response of the monitoring system to these warning levels is shown Tale 2.
Table 2
OPERATION    
Warning Category    Warning Indications (1)    Required Action by the Operator    Possible Result (4)    
Alert Indicator Flashes (2) Action Lamp Flashes    Action Alarm Sounds    
1     X             No immediate action required, te system needs attention soon     No harmful or damaging effects    
2     X     X         Change machine operation or perform maintenance to the system     Damage to system components    
3     X     X     X (3)     Immediately perform a safe machine shutdown     Operator injury or severe damage to components    
( 1 ) The active warning indications are marked with an "X".
( 4 ) The possible result if no action is taken .
( 2 ) At a 10 Hz rate.
( 3 ) Pulsating alarmIndications
When an abnormal operating condition occurs in VIMS, the Cat ET status screen indicates that there is an active event.Event codes are displayed on Cat ET in the following format:EXXXX Description of the codeThe "E" means that the code is an event code. The "XXXX" is a numeric identifier. The numeric identifier is followed by a description of the code. Active event codes are listed in ascending numerical order, the code with the lowest number is listed first. The active event code is removed from the list when the condition is no longer present.Logged Event