CONNECTING ROD GP 2874033 - Caterpillar

Illustration 1 g00697157
Enter a valid "User Name" and enter a valid "Password". After the password has been entered, the menu option will change. The menu bar will now contain a "Op. Params." option.
Select "Op. Group 6: Disable Auto Start / Modem Enable".
Set the "Operating Parameter Modem Enable" to "1" and press "Send".
Select the "Op. Group 6: Disable Auto Start / Modem Enable" from the "Op. Params." pull-down menu.
Select the type of the modem that is being installed from the following list. Enter the value for the type of Modem and press "Send".
Table 1
Types of Modems    
Number    Type    
1     3Com Courier V. Everything External    
2     Zoom    Note: The 3Com Courier V. Everything External and Zoom modems are the only two external modems that have been qualified to operate with the UPS. The customer is responsible for providing a receptacle that is protected by the UPS in order to supply power for the modem.The switches on only the US Robotics modems must be set to match the values that are listed in the following table.
Table 2
Switch settings for the 3Com Courier V. Everything External Modem    
Switch    Position    
1     ON ("DTR Always On")    
2     ON ("Numeric Result Codes")    
3     ON ("Display Result Codes")    
4     ON ("No Echo Offline Commands")    
5     OFF ("Auto Answer on Ring")    
6     OFF ("Normal Carrier Detect")    
7     OFF ("Display All Result Codes")    
8     ON ("Enable AT Command Set")    
9     OFF ("No disconnect with +++")    
10     OFF ("Load NVRAM Defaults")    
Press "Control R". Press "Y" in order to reset the UPS.
With the UPS View application, initialize the internal NVRAM for the modem by entering "Control-Q" after the UPS resets. After the NVRAM has been initialized, the screen should show the current settings for the modem. If the screen displays "Modem Error - Modem not responding", enter the "Control-Q" again. If the modem does not respond, check the cables and check the power supplies.
Use the front display panel of the UPS in order to enter the "pager numbers" and the "callback numbers". Use the front display panel of the UPS in order to change "pager numbers" and the "callback numbers". If paging is not desired, leave the pager number set to all blanks.Setting Up the Pager Silence Interval
The Pager Silence Interval is the function that allows the paging service to complete the "Welcome Message" before the message for the numeric page is input.
From a telephone, dial the telephone number for the pager that was just setup in the system.
After you dial the last digit, use a watch in order to count the number of seconds from the time of the dial of the last digit to the end of the "welcome message".The following sentence is a typical automated "welcome message": You have reached an XYZ numeric pager. Enter the numeric message, and press the "Pound" key.
When the automated "welcome