CONNECTOR 0951342 - Caterpillar

Illustration 14 g00638425
Install grapple control valve (36) on the rods.
Install three shims (35) .
Illustration 15 g00638424
Install ball (33) in rotate control valve (20). Install the seals and seat (34). Tighten the seat to a torque of 14 2 N m (124 18 lb in).
Install the seals and valve (32). Tighten valve (32) to a torque of 14 2 N m (124 18 lb in).
Install the O-Ring seals and two plugs (31) .
Illustration 16 g00638423
Install two springs (28) and sleeve (29) .
Install the seals and plug (30) .
Install spring (25), the two retainers, and the nut on spool (26) .
Install spool (26) .
Install spring (27), the two retainers, and the nut. Tighten the nuts on springs (25) and (27) to a torque of 11 1.5 N m (97 13 lb in).
Illustration 17 g00638421
Install the O-Ring seals and two housings (24) .
Install five bolts (23). Tighten the bolts to a torque of 8 1 N m (71 9 lb in).
Illustration 18 g00638420
Install two solenoids (21) .
Install eight O-Ring seals (22) .
Illustration 19 g00638417
Install rotate control valve (20) on the rods.
Install three shims (19) .
Illustration 20 g00638415
Install ball (17) in swing control valve (4). Install seat (18). Tighten the seat to a torque of 14 2 N m (124 18 lb in).
Install the seals and valve (16). Tighten the valve to a torque of 14 2 N m (124 18 lb in).
Install the seals and two relief valves (15). Tighten the relief valves to a torque of 70 7 N m (52 5 lb ft).
Illustration 21 g00638413
Install two springs (12) and sleeve (13) .
Install the seal and plug (14) .
Install spring (9), the two retainers, and the nut on spool (10) .
Install spool (10) .
Install spring (11), the two retainers, and the nut. Tighten the nuts on springs (9) and (11) to a torque of 11 1.5 N m (97 13 lb in).
Illustration 22 g00638412
Install the O-Ring seals and two housings (8) .
Install five bolts (7). Tighten the bolts to a torque of 8 1 N m (71 9 lb in).
Illustration 23 g00638411
Install two solenoids (5) .
Install eight O-Ring seals (6) .
Illustration 24 g00638410
Install swing control valve (4) on the rods.
Install three shims (3) .
Illustration 25 g00638409
Install cover (2) on the rods.
Install the washers and three nuts (1). Tighten the nuts to a torque of 27 5 N m (20 4 lb ft).End By: Install the grapple control valve (swing boom).