CONNECTOR 1394572 - Caterpillar

1. Maintain the oil level above the ADD COLD mark on the sight gauge located on the left side of the machine.2. Open the access door located on the left side of the machine. 3. Remove the oil fill cap and add oil, if necessary, through the fill tube. Refer to the Lubricant Viscosities and Refill Capacities section of this manual.4. Clean and install the fill cap. RadiatorLook at the Coolant Level
1. Maintain the coolant level in the sight gauge located on the left side of the machine.If it is necessary to add coolant daily, check for leaks. 2. The radiator cap is located in the top hood of the machine at the left rear. Remove the radiator cap slowly to relieve pressure.3. Inspect the cap and cap seal for damage, deposits or foreign material. Clean the cap with a clean cloth or replace the cap if it is damaged.4. Install the cap.5. Inspect the radiator core for debris and clean if necessary.Compressed air is preferred, but high pressure water or steam can be used to remove dust, leaves and general debris from a radiator. Clean as required by condition of radiator. Fuel SystemDrain Water Separator Bowl
Inspect or service the water collection bowl on the bottom of the water separator.1. Open the drain bowl. Some models may have a head mounted priming relief valve. If equipped, press the valve in and hold while pumping the water out.2. Close the drain. Fuel TankDrain the Water and Sediment
The Drain valve is located at the left side of the machine under the fuel tank. 1. Open the drain valve and allow the water and sediment to drain.2. Close the drain valve. Walk-Around InspectionInspect Machine
Accumulated grease and oil on a machine is a fire hazard. Remove this debris with steam cleaning or high pressure water, at least every 1000 hours or each time any significant quantity of oil is spilled on a machine.
Keep a close watch for leaks. If leaking is observed, find the source and correct the leak. Check the fluid levels more frequently than the recommended periods if leaking is suspected or observed. Inspect the engine air intake screen for accumulation of dirt and debris. Clean if dirty. Make sure the air filter indicator piston is not in the red zone.Inspect the bucket and linkage for damage or excessive wear. Repair if damaged. Inspect the lower bucket pivot pins for leaks. These pins require a specific amount of oil to prevent the pin from failing. If a leak is detected refer to the section Lower Bucket Pivot Pins in Every 2000 Service Hours or 1 Years section of this manual.Inspect the lights for broken bulbs and lenses. Replace if broken.Inspect and remove any trash build-up in the engine compartment.Inspect the cooling system for leaks, faulty hoses and trash build-up. Correct any leaks and remove any trash from the radiator.Inspect all engine attachment belts for worn cracked or frayed edges. Replace if worn, cracked, frayed or broken.Inspect the hydraulic system for