CONNECTOR 1652138 - Caterpillar

Operating conditions and oil API Classifications will determine the amount of service hours for the PM Level 1 Maintenance Interval Schedule. Refer to Operation and Maintenance Manual , "Engine Oil and Filter - Change" for your specific oil change interval.Note: Ensure that the Safety Information, warnings, and instructions are read and understood before operation or maintenance procedures are performed.Note: Use fuel consumption, service hours, or calendar time, whichever occurs first in order to determine the maintenance intervals. Engines that operate in severe operating conditions may require more frequent maintenance.Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must also be performed.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Engine Air Cleaner Element (Dual Element) - Clean/Replace
Engine Oil Level Gauge - Calibrate
Engine Storage Procedure - Check
Ether Starting Aid Cylinder - Replace
Fuel System - Prime
Severe Service Application - Check
Daily
Air Starting Motor Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Cooling System Coolant Level - Check
Driven Equipment - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Check/Clean
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Power Take-Off Clutch - Check/Adjust/Lubricate
Walk-Around Inspection
Initial 20 to 40 Service Hours
Belt - Inspect
Between 250 Service Hours and 1000 Service Hours
Electronic Unit Injector - Inspect/Adjust
Engine Valve Lash - Inspect/Adjust
Engine Valve Rotators - Inspect
Every 6000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change
PM Level 1 - Every 14 500 L (3850 US gal) of Fuel or 250 Service Hours or 6 Months
Air Compressor Filter - Clean/Replace
Alternator - Inspect
Battery Electrolyte Level - Check
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Electronics Grounding Stud - Inspect/Clean/Tighten
Engine Air Cleaner Element (Dual Element) - Clean/Replace
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Protective Devices - Check
Fan Drive Bearing - Lubricate
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Radiator - Clean
PM Level 1 - Every 29 000 L (7700 US gal) of Fuel or 500 Service Hours or 6 Months
Air Compressor Filter - Clean/Replace
Alternator - Inspect
Battery Electrolyte Level - Check
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Electronics Grounding Stud - Inspect/Clean/Tighten
Engine Air Cleaner Element (Dual Element) - Clean/Replace
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Protective Devices - Check
Fan Drive Bearing - Lubricate