CONNECTOR AS 3510276 - Caterpillar

EMCP 3 can be used for monitoring and control of MUI engines. With the absence of an engine ECM, the EMCP 3 uses relay outputs to control the following:
The EMCP 3 uses relay outputs to control the starting and stopping of the engine.
The EMCP 3 uses analog resistive sender inputs to monitor critical engine parameters.ReferenceFor EMCP 3 configuration settings that are specific to MUI engine applications, refer to Testing and Adjusting, "Electronic Control Module (Generator Set) - Configure", "Set Point Tables".MUI engine start/stop control by EMCP 3
Relay output 1 is used to energize the starter motor magnetic switch that is used to crank the engine.
Relay output 2 gives run signal to engine governor.
Additional relay output can be configured for "rated speed") gives permissive signal to engine governor to ramp up to rated speed.Note: Relay output 1 and 2 cannot be configured.The follow is a list of MUI engine parameters that are monitored by the EMCP 3:
Engine speed (via MPU input)
Oil pressure (via analog input 1)
Coolant temperature (via analog input 2)
Spare input (only EMCP 3.3 and EMCP 3.2)