CONNECTOR 3C3936 - Caterpillar

Ignition systems can cause electrical shocks. Avoid contacting the ignition system components and wiring.Do not attempt to remove the valve covers when the engine is operating. The transformers are grounded to the valve covers. Personal injury or death may result and the ignition system will be damaged if the valve covers are removed during engine operation. The engine will not operate without the valve covers.
Turn the engine control switch to the OFF/RESET position. Switch the circuit breaker for the engine OFF.
Remove the valve cover of the suspect cylinder.
Pulling on the wiring harness may break the wires. Do not pull on the wiring harness.
Disconnect the ignition harness from the transformer. Remove the transformer from the engine.
Illustration 1 g00715304
(1) Screw for the ground spring
(2) Ground spring
(3) Spacer
(4) Terminal for the spark plug
(5) Extension
(6) O-ring seal
Inspect the body of the transformer and ground spring (2) for corrosion and/or damage. Verify that screws (1) for the ground spring are secure. Note: Punch through is caused by misfire in the engine that does not generate a diagnostic code.
Check the extension near spacer (3) for signs of punch through (pin holes) and/or arcing.
Inspect O-ring seal (6) inside the extension for damage.
Remove O-ring seal (6). Inspect terminal (4) inside the extension for looseness, corrosion, and/or damage. Insert an extra spark plug into the transformer and check for spring pressure of terminal (4).
The extension can be scratched and damaged with a wire brush. Do not use a wire brush on the extension.
Clean any deposits from the inside of the extension. Use a 6V-7093 Brush with isopropyl alcohol.
Illustration 2 g00814314
(1) Screw for the ground spring
(4) Terminal for the spark plug
(7) + Terminal
(8) - Terminal
Measure the primary circuit by checking the voltage of the diode.
Set the multimeter to the diode scale. Connect the multimeter leads to terminals (7, 8) of the 2-pin connector. The polarity of the leads is not important. Measure the voltage between the terminals. Record the measurement.
Reverse the multimeter leads. Measure the voltage between the terminals again. Record the measurement. One of the voltage measurements is approximately 0.450 VDC. The other measurement indicates an open circuit.
Measure the resistance of the secondary circuit.
Set the multimeter to the 40,000 Ohm scale. Measure the resistance between screw (1) for the ground spring and terminal (4) for the spark plug. Note: The resistance of the secondary coil will vary with the temperature. Illustrations 3 and 4 demonstrate the relationship between the secondary coil's resistance and the temperature. A reading that is within 1000 ohms is acceptable.Illustration 3 is a graph for the resistance of the following transformers: 199-9011 and 229-9753Illustration 4 is a graph for the resistance of the following transformers: 232-6350 and 259-2078
Illustration 3 g00863850
(Y) Resistance in ohms
(X) Temperature in degrees Celsius (degrees Fahrenheit)
Illustration 4 g01170387
Switch the suspect transformer with a transformer from a different cylinder that is known to be good. Install