CONNECTOR 3G8034 - Caterpillar

Disassembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-1857 Retaining Ring Pliers 1
B 1P-1855 Retaining Ring Pliers 1
C 9S-9152 Bearing Puller Gp 1 Start By:
Remove the auxiliary water pump. Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g01934713
Remove nuts (2), the lockwashers, body (1), and the gasket from housing (3).
Illustration 2 g01934717
Remove nut (6), washer (5), and gear (4) from the shaft assembly.
Illustration 3 g01934718
Remove key (7) and spacer (8) from the shaft.
Use Tooling (A) in order to remove retaining ring (9).
Illustration 4 g01934719
Remove locknut (10) that holds impeller (11) in place. Note: The locknut has left hand thread.
Remove impeller (11). Note: Impeller (11) has left hand thread.
Illustration 5 g01934721
Remove shim (12) and seal assembly (13).
Illustration 6 g01934733
Use a suitable press to remove shaft assembly (14) and the bearings as a unit from body (1).
Illustration 7 g01934736
Use Tooling (B) in order to remove retaining ring (18) from the shaft assembly.
Use Tooling (C) and a suitable press to remove bearing (15), spacer (16), and bearing (17) from the shaft assembly.
Illustration 8 g01934737
Remove lip seal (20) and slinger (19) from body (1).