CONNECTOR-BHD 4396146 - Caterpillar

Illustration 1 g01096494 (1) Exhaust lobe (2) Injector lobe (3) Inlet lobe Note: Prior to installation, lubricate the camshaft lobes with a 50/50 mixture of 8T-2998 Lubricant and clean engine oil. (4) Bearing journal Diameter of the bearing journals ... 84.85 0.02 mm (3.341 0.001 inch)Note: Lubricate the camshaft bearings with clean engine oil prior to installing the camshaft. (5) Front of camshaft
Illustration 2 g01331010 (A) Camshaft lobe lift Specified camshaft lobe lift Exhaust lobe ... 8.515 mm (0.3352 inch)Inlet lobe ... 9.702 mm (0.3820 inch)Injector lobe ... 10.445 mm (0.4112 inch) (B) Camshaft lobe height (C) Base circle To find the lobe lift, use the procedure that follows:
Measure camshaft lobe height (B).
Measure base circle (C).
Subtract the base circle measurement (Step 2) from the camshaft lobe height (Step 1). The difference is the actual lobe lift. Maximum permissible difference between the actual lobe lift (Step 3) and the specified lobe lift of a new camshaft ... 0.1 mm (0.004 inch)
Illustration 3 g01331009 (6) Screw Tighten the screws that fasten the cover to the cylinder head to the following torque. ... 13 3 N m (10 2 lb ft)