CONNECTOR 5306772 - Caterpillar

This diagnostic code is associated with the Right Drive Pump Reverse Control Solenoid. The FMI 13 diagnostic code is activated when the ECM detects a solenoid that needs calibration.The ECM provides a PWM signal in order to control the solenoid. The ECM will vary the electrical current of the PWM signal in order to provide proportional control of the solenoid.Note: Before performing this procedure, verify that no other active CID 1703 diagnostic codes exist for the solenoid. If any other diagnostic codes are active for the solenoid, correct the problem before performing this procedure.System Response:A Level 1 warning is generated.Test Step 1. CALIBRATIONPerform the calibration procedure for the solenoid. Refer to Testing and Adjusting, "Propel Currents - Calibration" in order to perform the calibration. Refer to Table 1 for the manual specific to your machine model.
Table 1
"Propel Systems Operation" manuals
Machine Prefix Media Number
J3H UENR2020
TLJ UENR2051 Expected Result:The calibration procedure was performed successfully.Results:
OK - The calibration procedure was performed successfully. Resume normal machine operationSTOP
NOT OK - The calibration was not successful.Repair: Repeat the calibration procedure for the solenoid. STOP