5P9097 CONNECTOR-PORT Caterpillar parts
245D, 950B, 950B/950E, 966D, D10, R1700 II, R2900G, R3000H, W330B
Rating:
Alternative (cross code) number:
CA5P9097
5P-9097
5P9097
CA5P9097
5P-9097
5P9097
Weight: 0.05 pounds 0 kg.
Information:
JIC DASH SIZE
6
JIC THREAD SIZE
.56-18
ORIFICE SIZE
1.2
OVERALL LENGTH
33
mm
STOR DASH SIZE
6
STOR SEAL PART NUMBER
3J1907
STOR THREAD SIZE
.56-18
EXCAVATOR, WHEELED EXCAVATOR,
Compatible equipment models: 5P9097:
Number on catalog scheme:
6
For full view, you need register
Information:
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.
The fuel system should be primed after a unit injector is changed or when the fuel system is totally dry.Note: The fuel system does not typically need to be primed when the primary fuel filters or secondary fuel filters are changed or when an Electronic Control Module (ECM) is replaced. When the engine is started under these circumstances, the engine may momentarily run rough until the air is purged from the system.
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over any disconnected fuel system components.
Illustration 1 g01275925
The right side view of a typical C27 or C32 engine that is configured for a genset is shown below.
Illustration 2 g01275944
The secondary fuel filter gp is shown below.
(1) Fuel priming pump
(2) Fuel filter base
(3) Secondary fuel filter
(4) Priming pump plunger Follow the procedure below in order to prime the engine with fuel.
Turn the priming pump plunger (4) counterclockwise in order to unlock the plunger. Manually pump the plunger in order to fill the fuel lines and the fuel filters with fuel.
As the air is purged from the fuel system, fuel pressure will increase. This will create resistance in the plunger. Continue to pump the plunger until a strong resistance is felt. The number of strokes will vary with the amount of air in the fuel lines.
After resistance is felt in the plunger, push in the plunger. Lock the plunger by turning the plunger clockwise.
Start the engine at low idle.
If the engine runs rough, continue to run the engine at low idle until the engine runs smoothly.
Do not crank the engine continuously for more than 30 seconds. Allow the starting motor to cool for two minutes before cranking the engine again.
Caterpillar parts catalog:
Parts connector Caterpillar catalog:
120G, 12G, 130G, 14G, 16G, 173B, 183B, 193, 215, 215B, 215C, 227, 235B, 235C, 235D, 245, 245B, 245D, 3606, 3608, 3612, 3618, 518, 561C, 561D, 571G, 589, 623B, 768C, 769C, 773B, 777, 777B, 785, 814B, 8...
10 FT, 10-20B, 10B, 120G, 12G, 130G, 140G, 14G, 160G, 3606, 3608, 3618, 621, 623, 627B, 631C, 637B, 641, 641B, 650B, 651, 657, 657B, 666, 666B, 768B, 769, 772, 8 FT, 8-16B, 920, 936F, 950, 950B, 966C,...
215, 215B, 225, 227, 245D, 3512B, 3606, 3608, 3616, 633C, 769C, 773B, 777, 777B, 784B, 784C, 785, 785B, 785C, 789B, 793B, 824B, 910, 916, 926, 930R, 931, 931B, 933, 935B, 936, 938G II, 939, 950G II, 9...
120G, 12G, 130G, 140G, 14G, 3192, 3304, 3306, 3408, 3408C, 3412, 518, 528, 528B, 530B, 561D, 621G, 623G, 627E, 627G, 631G, 637E, 637G, 651E, 657E, 657G, 7251, 7261, 814, 814B, 815, 815B, 816, 816B, 82...
16M, 24H, 24M, 3406E, 3508C, 3512B, 3512C, 3516B, 3516C, 365C, 365C L, 365C L MH, 374D L, 385B, 385C, 385C FS, 385C L, 385C L MH, 390D, 390D L, 5090B, 5110B, 5130, 5130B, 518C, 5230, 5230B, 561H, 561M...
153, 163, 183B, 215, 215D, 225, 227, 229, 235, 235B, 235C, 235D, 245, 245B, 307B, 311B, 312B, 312B L, 315B, 315B FM L, 315B L, 317B LN, 318B, 320, 320 L, 320B, 320B FM LL, 320B L, 320B U, 320N, 321B, ...
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 12G, 12H, 12H ES, 12H NA, 12K, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14G, 14H, 14H NA, 160G, 160H, 160H ES, 160H NA, 160K, ...
518, 518C, 528, 528B, 530B, 631E, 631G, 633E II, 637E, 637G, 814, 814B, 815, 815B, 816, 816B, 916, 920, 930, 930R, 936, 936F, 950, 966C, 966D, 966R, 980, D348, D349, D398, D399, FB518, G936, IT18B
120G, 12F, 130G, 1673C, 3406, 3408, 518, 528, 55, 57, 571G, 578, 58, 583K, 594H, 621E, 621F, 623E, 623F, 627E, 627F, 631E, 633E II, 637E, 651E, 657E, 768B, 769, 772, 773, 784C, 785B, 785C, 785D, 789B,...
12M, 140G, 140M, 160M, 245, 245B, 245D, 3116, 3126, 3126B, 3126E, 324D, 324D FM, 324D FM LL, 324D L, 324D LN, 325D, 325D FM, 325D FM LL, 325D L, 325D MH, 326D L, 328D LCR, 329D, 329D L, 329D LN, 611, ...
12G, 130G, 14E, 14G, 16G, 173B, 183B, 193, 225, 225D, 227, 229, 229D, 231D, 307, 311, 311B, 312, 312B, 312B L, 315, 315B, 315B L, 317, 317B LN, 318B, 320, 320 L, 320B, 320B FM LL, 320B U, 320N, 3P, 51...
120B, 140B, 225, 235, 245, 518, 525C, 528, 535C, 545C, 814, 815, 816, 910, 920, 930R, 931B, 941, 950, 955L, 966C, 966R, 977K, 980B, 983, AP-1055D, BG-2455D, BG-260D, D3, D3B, D3C, D4C, D4D, D5, R1300,...
6E5448
CONNECTOR AS
235D
235D
0337694
CONNECTOR
212, AP-800
212, AP-800
6C4328
CONNECTOR
235C, 245B
235C, 245B
120G, 12G, 130G, 140G, 16G, 245, 578, 583R, 589, 623G, 627G, 769C, 773B, 826C, 834B, 836, 844, 980C, 980F, 988B, 988F, 988F II, 990, 990 II, 992C, 992D, D25D, D7R, D8N, D8R, D8R II
5W1979
CONNECTOR
205, 206, 206B, 211B, 212, 212B, 213B, 214B, 224B
205, 206, 206B, 211B, 212, 212B, 213B, 214B, 224B
5W1970
CONNECTOR
205, 205B, 206, 206B, 211B, 212, 212B, 213B, 214B, 224B
205, 205B, 206, 206B, 211B, 212, 212B, 213B, 214B, 224B
5W9288
CONNECTOR
206, 206B, 212, 212B, 214B, 224B
206, 206B, 212, 212B, 214B, 224B