CONNECTOR 8C6875 - Caterpillar

Certain parameters are unique for each engine application. Table 1 is a list of the parameters that can be configured for G3520E+ Engines. The parameters are programmed into the Electronic Control Module (ECM) via the Caterpillar Electronic Technician (ET). The values of the parameters can be viewed on the "Configuration" screen of Cat ET.Refer to Systems Operation/Testing and Adjusting, "Electronic Control System Parameters" for the descriptions of the parameters.
Table 1
Configuration Parameters for G3520E+ 2.0 MW    
Description    Default Value    Minimum Value    Maximum Value    
ECM Identification Parameters                
"Equipment ID"     17 alphanumeric characters            
"Engine Serial Number"     0XX00000 or XXX00000            
Timing Control                
"First Desired Timing"
    24 deg BTDC for 1.0 MW     10 deg BTDC     40 deg BTDC    
"Second Desired Timing"     14 deg BTDC     10 deg BTDC     40 deg BTDC    
Air/Fuel Ratio Control                
"Fuel Quality Input Type Configuration" (1)     Configured Value            
"Fuel Quality"     35.4 MJ/nm3
900 BTU     9.8 MJ/nm3
250 BTU     94.5 MJ/nm3
2400 BTU    
"Fuel Quality Sensor LHV Lower Limit" (1)     11.8 MJ/nm3
300 BTU     7.9 MJ/nm3
200 BTU     25.6 MJ/nm3
650 BTU    
"Fuel Quality Sensor LHV Upper Limit" (1)     33.5 MJ/nm3
850 BTU     19.7 MJ/nm3
500 BTU     94.5 MJ/nm3
2400 BTU    
"Gas Specific Gravity"     .6     0     2    
"Fuel Specific Heat Ratio"     1.3     1     2    
"Desired Emission Gain Adjustment Percentage"     100%     85%     115%    
"Air/Fuel Proportional Gain"     0     -50     50    
"Air/Fuel Integral Gain"     0     -50     50    
Speed Control                
"Low Idle Speed"     1000 rpm     500 rpm     1300 rpm    
"Minimum Engine High Idle Speed"     1400 rpm     900 rpm     1500 rpm    
"Maximum Engine High Idle Speed"     1600 rpm     1500 rpm     1900 rpm    
"Engine Acceleration Rate"     50 rpm     1 rpm     50000 rpm    
"Desired Speed Input Configuration"     0-5 VDC Input            
"Governor Type Setting"     Isochronous            
"Engine Speed Droop"     0%     0%     10%    
"Governor (Proportional) Gain Percentage"     100%     10%     500%    
"Governor (Integral) Stability Percentage"     100%     10%     500%    
"Governor Auxiliary 1 (Proportional) Gain Percentage"     100%     10%     500%    
"Governor Auxiliary 1 (Integral) Stability Percentage"     100%     10%     500%    
Start/Stop Control                
"Driven Equipment Delay Time"     120 sec     0 sec     600 sec    
"Crank Terminate rpm"     250 rpm     100 rpm     600 rpm    
"Engine Purge Cycle Time"     0 sec     0 sec     60 sec    
"Cooldown Duration"     0 min     0