CONNECTOR ASSEMBLY 9L7132 - Caterpillar

Machine Stopping
Park on a level surface. If it is necessary to park on a grade, block the wheels securely.Engage the parking brake.
1. Apply the service brakes to stop the machine. 2. Engage the parking brake.3. Lower the equipment to the ground and apply a slight down pressure.Engine Stopping
Stopping the engine immediately after it has been working under load can result in overheating and accelerated wear of the engine components.Refer to the following stopping procedure to allow the engine to cool.To prevent excessive temperatures in the turbocharger center housing, (if equipped) which could cause oil coking problems.
1. With the machine stopped, run the engine for five minutes at Low Idle. Stopping the engine immediately after it has been working under load, can result in overheating and accelerated wear of the engine components. 2. Turn the start switch key to OFF and remove the key.Leaving the Machine
1. Use the steps and handholds. Use both hands and face the machine, when dismounting. Make sure the steps are clear of debris before dismounting. 2. Inspect the engine compartment for debris. Clean out any debris and paper to avoid a fire.3. Remove all flammable debris from front bottom guard open the access doors to reduce fire hazard. Dispose of debris properly.4. Turn the battery disconnect switch key to OFF and remove the key when leaving the machine for an extended period of a month or longer. This will prevent battery drain by short circuits or current draw made by some of the components, or by vandalism.5. Install all vandalism protection covers and locks.