CONSOLE AS-OUTER 1869254 - Caterpillar

Illustration 11 g01721397
The "Over the Air Configuration" screen due to selecting multiple equipment (3) "Manufacturer" parameter and "Serial Number" parameterNote: If you select more than one piece of equipment for configuration at the same time, you must set all the parameters to the same value. Only the "Manufacturer" parameter and "Serial Number" parameter (3) can be set separately. These fields can not be edited on the "Over The Air Configuration" screen if multiple machines have been selected."Send Commands"
The "Send Commands" feature enables you to force the PLM to immediately send messages rather than waiting for the next interval of transmission. This could be useful if you needed to know information such as the immediate location or SMU of the machine. "Send Commands" is also where you can register and deregister the PLM for purposes of moving the module from one machine to another.In order to send commands, use the following procedure:
From the "Administration" screen or the "View" drop-down menu, select "Send Commands". The "Equipment Search" screen will appear.
Select the criteria of your search and/or type the criteria of your search. Then click "Display Equipment". The "Send Commands" screen will appear and the screen will display the results of the search.
Illustration 12 g01721398
"Send Commands" (4) Check boxes (5) "Status" check box (6) "Event" check box (7) "Send" button
In order to send commands, select the check box that corresponds to the machine from the most left column. In the remaining columns, select the check box that corresponds to the type of command.Note: Selecting the check box (4) in the first column of the "Send Commands" table automatically selects the "Status" check box (5) and "Event" check box (6) for that selected item. Because the "Status" command returns reports about "Location", "SMU" and "Fuel", there is no reason to send any of these three commands if "Status" is selected.Table 7 describes the type of commands that can be sent.
Table 7
"Send Commands" Options    
Subscriptions    Command    Description    
Asset Watch    Maint. Watch    Health Watch    
X             Location     Sends report with location information of machine.    
X             SMU     Sends report with information about current Service Meter Units.    
        X     Fuel     Sends report with information about fuel consumption.    
X             Status     Sends report with information about Location, SMU, and Fuel.    
    X         Event     Sends report with Level 1, 2 and 3 event messages that have been collected from ECMs on machine since last transmission.    
X     X     X     Reg Request     Request that a new registration message be sent.    
X     X     X     Forced DegReg     The "Forced Deregistration" is useful if you know that a module has been removed without being de-registered from the old machine. The "Forced Deregistration" will remove the registration from EquipmentManager.    
X     X     X     DegReg     Use