CONSOLE GP-OPERATOR 3899292 - Caterpillar

Table 1
ADVISOR DISPLAY OPERATIONS    
Level     Action Alarm     Alert Indicator     Pop-Up Message     System Warning Indicator    
1     OFF     OFF     OFF     ON    
2     OFF     Flashes ON-OFF     ON     ON    
3     Pulses ON-OFF     Flashes ON-OFF     ON     ON    Note: "Level 2" warnings will use the Advisor Display Pop-Up Message for a certain fault. A "Level 2" warning will determine if the Advisor Display Pop-Up Message is used.Conditions that will activate the operator error indicator:
Material height measurements change from "paddle sensor" to "sonic sensor" during paving operations.
Incorrectly installed left and right speed sensors.
Any feeder system switch in the manual position during engine start-up.
The machine is operating in open loop mode.
The machine is in a Runaway condition.
Gear changes with propel lever out of Neutral.
Machine controller sends an engine fuel shutdown during paving operations.
Change of station commands with propel lever out of Neutral.
Sonic sensor signals greater than 94% duty cycle.
Propel lever is out of Neutral and the parking brake is set.
Screed lift switch is in the down position, while turning the key switch to the ON position.
Illustration 1 g02544619
Typical AdvisorDisplay Pop-Up MessageThe action that is taken by the machine operator for the different warning levels is listed below:Level 1 - This warning level will illuminate the involved system alert indicator. A "Level 1" warning indicates that the operator should be aware of a condition in one or more of the machine systems.Level 2 - This warning level will indicate that the operation of the machine should be changed or that maintenance should be performed to the machine. Possible damage to components on the machine may occur without a change in operation or maintenance.Level 3 - Injury to operator or severe component damage may occur. This warning level requires an immediate safe emergency shutdown response.If an action alarm, alert indicator, or a warning occurs, a popup message will override any screen that was displayed on the Advisor display module.When a warning message is displayed on the Advisor display module, press the "OK" button in order to acknowledge the warning. Pressing the OK button will remove the warning message from the display for a predetermined duration of time. Refer to Table 2.
Table 2
Warning Acknowledgment Durations    
Warning Level    Duration    
Level 1     1 hour    
Level 2     1 hour    
Level 3     1 hour