CONSOLE 5143007 - Caterpillar

Personal injury or death can result from a work tool falling.Keep personnel away from the front of the machine when lowering the work tool.
Before lowering any equipment with the engine stopped, clear the area around the equipment of all personnel. The procedure will vary with the type of equipment that is lowered. Keep in mind that most systems use a high-pressure fluid or air to raise or lower the equipment. The procedure will cause high-pressure air, hydraulic fluid, or some other media to be released to lower the equipment. Wear appropriate personal protective equipment and follow the established procedure in the Operation and Maintenance Manual, "Equipment Lowering with Engine Stopped" in the Operation Section of the manual.Lowering the Equipment with the Accumulator Charged
If electrical power is available and the accumulator is charged, the loader arms can be lowered from the operator station with the work tool control.
Fasten the seat belt. Lower the armrests.
If machine security is installed, key in a valid Master Code or Operator Code. See "User Management, Master Code, and Operator Code".
Move the engine start switch to the ON position. Press the parking brake switch and release the parking brake switch.Note: The parking brake indicator will remain illuminated since the engine is not running. When the indicator for the work tool is no longer illuminated, the pressure can be released.
Slowly move the work tool control to the LOWER position toslowly lower the loader arms.If the loader arms do not lower, the accumulator is not charged. It is possible to recharge the accumulator by cranking the engine for 15 seconds. Repeat step 3 and 4.If there is no electrical power the loader arms must be lowered by using the procedure that is explained next.Alternate Lowering the Equipment
Personal injury can result from oil under high pressure.DO NOT allow high pressure oil to contact skin.Wear appropriate protective equipment while working with high pressure oil systems.
The loader arms must be lowered manually if the accumulator is not charged or if there is no electrical power.Do not go under the raised lift arm without the brace for the loader lift arm in the LOCKED position.Note: Make sure that there are no people near the front or sides of the machine.
Illustration 1 g01400888
Type 1 Pull Handle near Seat.
Illustration 2 g03821246
Type 2 Roof-mounted Finger Latch
The bypass valve (Dead Engine Lower) may be located either on the left side next to the seat in the cab (Type 1) or overhead on the underside of the cab roof (Type 2).
Illustration 3 g01332374
Film located next to the red handle (Type 1) or icon molded into the finger latch (Type 2).
Type 1 Actuation
Slide the seat forward. Slide the left-hand armrest forward.
Pull up on the red handle. Push the handle to stop the loader arms,