CONT GP -E 10R8115 - Caterpillar

1. Disconnect rod assembly (1) for decelerator linkage at the pedal assembly. 2. Remove floor plate (2).3. Open the panel assembly on the right side of the support and seat group. 4. Disconnect rod assembly (3).5. Disconnect rod assemblies (4) and (5). 6. Remove guide (6) from the transmission control console.
Make sure the cable assemblies are disconnected from the batteries.
Typical Example 7. Remove disconnect switch (7).8. Remove eight bolts (8) that hold the support and seat group to the fenders on the machine.
Typical Example9. Use forged eyebolts to fasten a hoist to the support and seat group. Fasten a hoist to the support and seat group and remove it slowly from the machine. The weight of the support and seat group (9) is 180 kg (400 lb).
Do not cause damage to the battery support, filler spouts or shifting lever assemblies as the support and seat group is removed.
The following steps are for installing the support and seat group.
Do not cause damage to the battery support, filler spouts or shifting lever assemblies as the support and seat group is lowered into position.
10. Fasten a hoist to the support and seat group (9). Put the unit in position on the fenders of the machine. Install the eight bolts that hold it.11. Install disconnect switch (7).12. Install guide (6) for the transmission control console.13. Connect two rod assemblies (4) and (5).14. Connect rod assembly (3).15. Install floor plate (2).16. Connect rod assembly (1).End By:a. install Roll-Over Protective Structure (if so equipped)