CONT GP -E 10R8130 - Caterpillar

1. Remove five bolts (6) and bracket (5).2. Loosen clamps (1) and remove breather group (2) from the valve cover.3. Remove three bolts (3) that hold the clips, wire harness for the glow plugs and the water temperature sending unit line to the valve cover. Remove glow plug wire harness (4). 4. Remove fifteen bolts (7) and valve cover (8). Remove the gasket from the valve cover.Install Valve Cover
1. Put 5H2471 Cement on the face of valve cover (1) and the top side of the valve cover gasket. Put the valve cover in position on the cylinder head. Install the fifteen bolts that hold it. Tighten the bolts in number sequence to a torque of 10.9 2.8 N m (96 24 lb. in.).2. Connect the wire harness to the glow plugs. Put the wire harness in position in the valve cover and install the three bolts and three clips.3. Put the water temperature sending unit line in position on the valve cover and bend the clips over the wire. 4. Install the breather group in the valve cover. Tighten the bolt in the breather group to a torque of 14 3 N m (10 2 lb. ft.). Tighten the hose clamps on the breather group.5. Install the tube support bracket for the hydraulic tube assemblies.end by:a) install air cleaner assemblyb) install hood, muffler and precleaner assembly