AVSPARE.COM
parts catalog

CONT GP-IMPL 3236501 - Caterpillar



3236501 CONT GP-IMPL Caterpillar parts CONT
Rating:
16
Alternative (cross code) number:
CA3236501
323-6501
3236501
Caterpillar 3236501 CONT GP-IMPL

Buy CONT GP-IMPL 3236501 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 3 g01159115
Use Tooling (G) and a suitable lifting device to position axle housing (2) over the axle shaft, as shown. The weight of axle housing (2) is approximately 155 kg (342 lb).
Raise the temperature of bearing cone (12).
Install bearing cone (12) on the axle shaft so that there is slight end play. When bearing cone (12) is cool, apply clean SAE 30 oil to the bearing cone.Note: Bearing nut (11) must be installed so that the part number is facing away from bearing cone (12).
Apply clean SAE 30 oil on bearing nut (11) and install bearing nut (11) on the axle shaft. Tighten the nut until a small amount of end play remains.
The seal drag torque is the torque that is needed to rotate the axle housing. Use one of the following methods to measure the seal drag torque:
To measure seal drag torque, install Tooling (J) on the axle housing. Place a torque wrench on the bolt at the center of the bar. Use


Parts cont Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.