CONT GP 4502436 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Chain Wrench 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g02701759
Place a suitable container below engine oil filter (6) in order to catch any oil that might be spilled.
Use Tooling (A) to remove engine oil filter (6). Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change" for the correct procedure.
Remove bolts (4).
Remove engine oil filter base (3).
Remove gasket (5).
If necessary, remove valve (1) from engine oil filter base (3). Remove O-ring seal (2) from valve (1). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g02701759
Clean engine oil filter base (3). Clean the gasket surfaces of the engine oil cooler.
If necessary, install new O-ring seal (2) to valve (1). Install valve (1) to engine oil filter base (3). Tighten the valve to a torque of 12 N m (106 lb in).
Install bolts (4) to engine oil filter base (3).
Install a gasket (5) onto bolts (4). Install the assembly of the engine oil filter base to the engine oil cooler.
Tighten bolts (4) to a torque of 22 N m (195 lb in).
Install a new engine oil filter (6) and check the level of the engine lubricating oil. Refer to Operation and Maintenance Manual, "Engine Oil Level - Check" for the correct procedure.