CONT GP 4549940 - Caterpillar

7. Install the other fifteen bolts (8) that hold the flywheel clutch cover to the flywheel housing.8. Install the eight bolts and washers in the ring of the flywheel clutch. Turn the engine flywheel to install the bolts and washers.9. Put 8S6747 No. 3 Gasket Sealer on gasket and cover (10). Install gasket and cover. Install the six bolts and washers that hold the cover in position. 10. Install yoke (12). Install the O-ring, retainer, lock and two bolts that hold the yoke in position.11. Install two brake pedals (9) and (11). Connect rods (13) and (14) to brake pedals. Connect two springs (15) and (16) to brake pedals.12. Fill the flywheel clutch with oil to the correct level. See LUBRICATION AND MAINTENANCE GUIDE.end by: a) install crankcase guard (rear)b) install flywheel clutch brakec) install drive shaftFlywheel Clutch Adjustment
1. Make an adjustment to the flywheel clutch as follows: a) Remove the cover from the flywheel clutch. b) Turn the engine flywheel until locknuts (1) can be seen. Loosen locknut (1) two turns. Make sure the plate under the locknut is loose. Turn the flywheel 180°. Loosen the other locknut (1) two turns.c) Turn ring (2) until a force of 35 - 45 lb. (15.88 - 20.41 kg) pull is on the control lever of the flywheel clutch. Tighten locknuts (1). Install the cover on the flywheel clutch. d) Pull the control lever of the flywheel clutch back. Loosen locknut (5). Remove pin (6) and turn rod end (4) clockwise or counterclockwise until the control lever is in vertical position with pin (6) installed. Tighten locknut (5). Tighten locknut (5). Make sure rod (4) is connected to lever (3) as shown.Disassemble Flywheel Clutch (Direct Drive & Special Application)
start by: a) remove flywheel clutch1. Put the flywheel clutch on wood blocks as shown. Remove the wire and two forcing screws from the cover of the flywheel clutch. 2. Remove shaft (1). 3. Install two