CONT GP-LINES& 8U7615 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Bracket     2    Note: Verify that all of the components of the hydraulic tank for the steering and brake system are clean and free of foreign material prior to installation.Note: Check all of the O-ring seals and the components for wear or damage. Replace the components, if necessary. Lubricate the O-ring seals lightly with the lubricant that is being sealed.
Illustration 1 g00590465
Install Tooling (A) to the hydraulic tank for the steering and brake system. Fasten Tooling (A) to a suitable lifting device. Fasten the other end of the suitable lifting device to a hoist.
Install the hydraulic tank for the steering and brake system. Install six bolts (19) and the washers. The weight of the hydraulic tank is 220 kg (480 lb).
Illustration 2 g00590863
Connect the following items to the hydraulic tank: hose assembly (15), hose assembly (16), hose assembly (17) and hose assembly (18) .
Illustration 3 g00590860
Install two panel assemblies (14). Install 33 bolts (13) and the washers.
Illustration 4 g00590463
Connect hose assembly (12) to the hydraulic tank for the brake cooling.
Illustration 5 g00590461
Connect the temperature sender (11) (not shown) at the electrical connection.
Connect the temperature sensor (10) at the electrical connection.
Illustration 6 g00590456
Illustration 7 g00590459
Connect the following items to the hydraulic tank: hose assembly (2), hose assembly (3), hose assembly (4), hose assembly (5), hose assembly (6), hose assembly (7), hose assembly (8) and hose assembly (9) .
Illustration 8 g00589928
Install plug (1) to the hydraulic tank for the steering and brake system. Tighten plug (1) to a torque of 68 7 N m (50 5 lb ft).
Use the sight gauge on the side of the hydraulic tank in order to monitor the fill level. Fill the hydraulic tank for the steering and brake system. Refer to Operation and Maintenance, "Steering and Brake System Oil Level - Check".
Attach an air supply to the breather port of the hydraulic tank for the brake system. Use 150 35 kPa (22 5 psi) air pressure to test for leaks in the tank.End By: Install the hood. Refer to Disassembly and Assembly, "Hood - Install".