CONTACTOR A 0376861 - Caterpillar

Table 2
Component Identifier (CID)
Transmission ECM    
Code Number    Component    
70     Parking Brake Switch    
168     Electrical System Voltage    
177     Transmission Oil Temperature Sensor    
248     Data Link    
363     Ride Control Solenoid    
367     Ride Control Switch    
368     Transmission Auto/Manual Switch    
621     Downshift Switch    
622     Upshift Switch    
623     Direction Switch    
631     Solenoid (Transmission Clutch 1)    
632     Solenoid (Transmission Clutch 2)    
633     Solenoid (Transmission Clutch 3)    
634     Solenoid (Transmission Clutch 4)    
635     Solenoid (Transmission Clutch 5)    
636     Solenoid (Transmission Clutch 6)    
638     Starter Solenoid    
671     Transmission Output Speed Sensor 1    
687     Invalid Option Code    
Table 3
Component Identifier (CID)
Implement ECM    
Code Number    Component    
168     Electrical System Voltage    
248     Data Link    
270     CMS Harness Code    
296     Transmission ECM    
350     Lift Linkage Position Sensor    
352     Lift Lever Position Sensor    
353     Tilt Lever Position Sensor    
354     Solenoid (RAISE)    
355     Solenoid (LOWER)    
356     Solenoid (DUMP)    
357     Solenoid (TILT BACK)    
358     Solenoid (Pilot Pressure)    
359     Electromagnet (RAISE detent)    
360     Electromagnet (LOWER detent)    
361     Electromagnet (TILT BACK detent)    
365     Kickout Set Switch    
487     Third Lever Position Sensor    
488     Fourth Lever Position Sensor    
489     Implement Function Selection Switch    
491     Forward Solenoid (Third Lever)    
492     Rearward Solenoid (Third Lever)    
499     Implement Solenoid (Power Shift)    
596     Implement ECM    
687     Invalid Option Code    The Module Identifier (MID) is a diagnostic code that indicates the electronic control module that diagnosed the fault.
Table 4
Module Identifiers (MID)    
Code Number    Module    
30     Caterpillar Monitoring System    
81     Transmission ECM    
82     Implement ECM    The Failure Mode Identifier (FMI) is a diagnostic code that indicates the type of failure that has occurred.
Table 5
Failure Mode Identifier (FMI)    
Code Number    Description    
0     Data is valid but the operational range is above normal.    
1     Data is valid but the operational range is below normal.    
2     Data is erratic, intermittent, or incorrect.    
3     Voltage is above normal or there is a high short in the circuit.    
4     Voltage is below normal or there is a low short in the circuit.    
5     Current is below normal or there is an open circuit.    
6     Current is above normal or there is a grounded circuit.    
7     The mechanical system is not responding properly.    
8     The frequency, the pulse width, or the period is abnormal.    
9     The update is abnormal.    
10     The rate of change is abnormal.    
11     Failure mode cannot be identified.