CONTACTOR 3C9833 - Caterpillar

Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01260077
Remove bolts (1). Remove clips (2).
Illustration 2 g01260078
Remove bolt (4). Loosen bolt (5). Rotate elbow (3) out of the way. Remove the gasket from elbow (3).
Illustration 3 g01260080
Remove bolts (6). Remove bracket (7).
Illustration 4 g01260081
Remove tube assembly (8).
Illustration 5 g01260082
Remove bolts (9). Loosen hose clamp (12). Disconnect hose (13). Remove water temperature regulator housing (10) and the gasket. Remove the O-ring seal from tube assembly (11).
Illustration 6 g01260106
Disconnect harness assembly (14). Remove tube assembly (15).
Illustration 7 g01260109
Disconnect harness assembly (16).
Illustration 8 g01260110
Remove bolt (17) and remove clip (18).
Illustration 9 g01260114
Remove bolts (19). Remove bracket (20).
Illustration 10 g01260116
Disconnect harness assembly (21). Remove nut (22) and the washer. Position bracket (23) and the dipstick tube out of the way. Cut and remove cable straps (24).
Illustration 11 g01260204
Disconnect harness assembly (25). Remove tube assembly (26).
Illustration 12 g01260205
Illustration 13 g01260206
Remove bolts (27) and bolts (28).
Illustration 14 g01260207
Attach a suitable lifting device onto cylinder head (29). The weight of cylinder head (29) is approximately 118 kg (261 lb). Remove cylinder head (29) and the gasket from the cylinder block.