CONTACTOR-TEMPERATURE 5N8598 - Caterpillar

Table 1
Selection of Oil and Filter Change Interval
Conditions Interval
Cat Recommended Fluids Cat Filters S O S Services
Standard Service Application YES YES YES 1000 hours
YES YES NO 500 hours
YES NO YES 500 hours
NO YES YES 500 hours
NO NO NO 250 hours
Severe Service Application NO NO NO 250 hours
YES YES NO 250 hours
YES YES YES Use S O S(1)
YES NO YES Use S O S(1)
NO YES YES Use S O S(1)
(1) If operating in any of the conditions or environments outlined in the Severe Service Application, use S O S Services oil analysis to determine the best oil change interval.Procedure for Changing the Oil
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Do not under fill or overfill engine crankcase with oil. Either condition can cause engine damage.
Refer to the Operation and Maintenance Manual, "Hood Tilt" for the access to the engine.Park the machine on a level surface and engage the parking brake. Stop the engine.Note: Drain the crankcase while the oil is warm. Waste particles that are suspended in the oil will drain along with the oil. As the oil cools, the waste particles will settle to the bottom of the crankcase. The particles will not be removed by draining the oil and the particles will recirculate in the engine lubrication system with the new oil.
Open the engine hood to the fully open position.
Remove the left side engine panel.
Illustration 1 g03719183
The drain valve is on the left side of the oil pan. The drain valve can also be accessed from beneath the tractor. Open the oil drain valve and allow the oil to drain into a suitable container. Close the drain valve.
Illustration 2 g06322355
(1) Oil Fill
(2) Oil Dipstick
(3) Oil Filter
Clean the area around engine oil filter (3) before you remove the engine oil filter. Use a strap type wrench to remove the engine oil filter. Inspect the oil filter. Refer to Operation and Maintenance Manual, "Oil Filter - Inspect".
Clean the filter mounting base. Make sure that all of the used gasket has been removed.
Illustration 3 g00101318
Apply a thin coat of oil to the seal on the new engine oil filter. Install a new engine oil filter hand tight until the seal of the engine oil filter contacts the base. Note the position of the index marks on the filter in relation to a fixed point on the filter base.Note: There are rotation index marks on the engine oil filter that are spaced 90 degrees or 1/4 or a turn away from each other. When you tighten the engine oil filter, use the rotation