CONTACTOR-TEMPERATURE 7C4927 - Caterpillar

Removal Procedure
Start By:
Remove the V-Belt. Refer to Disassembly and Assembly, "V-Belts - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Turn the battery disconnect switch to the OFF position.
Make temporary identification marks on the connections of the harness assembly.
Illustration 1 g01308285
Typical example
Disconnect the harness assembly (not shown) from alternator (5).
Remove bolt (4) and washer (3) from alternator (5).
Remove washer (7) and nut (6). Remove bolt (8) and alternator (5) from the mounting bracket.
If necessary, remove bolt (1) and remove adjusting link (2). Installation Procedure
Illustration 2 g01308285
Typical example
If necessary, install adjusting link (2) and install bolt (1) finger tight.
Position alternator (5) on the mounting bracket.
Install bolt (8), washer (7) and nut (6) finger tight.
Install bolt (4) and washer (3) finger tight.
Install the V-Belt. Refer to Disassembly and Assembly, "V-Belts - Remove and Install". Note: Ensure that the alternator pulley is in alignment with the crankshaft pulley. Ensure that all fasteners are tightened.
Connect the harness assembly (not shown) to the alternator.
Turn the battery disconnect switch to the ON position.