CONTROL G. 0094060 - Caterpillar

1. Start the engine and lift the bowl until it is level. Put wood blocks (1) under the bowl to hold it in position.2. Retract the ejector fully. Stop the engine. Oil will drain out of the ejector cylinder when the hydraulic hoses are disconnected from it. Put plugs in the hoses and cylinder as they are disconnected.
View From Under Scraper3. Disconnect hose (4) from the rod end of the cylinder.4. Disconnect hose (2) from the tube assembly. Remove the clip from the tube assembly.5. Remove tube assembly (3).
View From Under Scraper Typical Example6. Put tool (A) and a lifting strap around the head end of the ejector cylinder as shown. Tool (A) will hold the cylinder up when the rear pin that holds the cylinder is removed.7. Remove two bolts (6) and lock, washer (5) and the pin that holds the head end of the cylinder in position.
View From Under Scraper8. Put wood blocks (7) on the