CONTROL AS- 1069189 - Caterpillar

SMCS Code: 6805-040; 6805-510
Personal injury or death can result from bucket falling.Block the bucket before changing bucket tips or side cutters.
Bucket Tips
Illustration 116
(1) This tip is usable. (2) This tip should be replaced. (3) This tip has been overworn.Check the bucket tips for wear. If the bucket tip has a hole, replace the bucket tip.
Illustration 1171. Drive the pin out of the bucket tip from the retainer side of the bucket tip. Remove the bucket tip and the retainer.
Illustration 1182. Clean the adapter and the pin.3. Fit retainer (1) into retainer washer (2). Install this assembly into the groove that is in the side of adapter (3).
Illustration 1194. Install the new bucket tip or the rotated bucket tip onto the adapter. To allow greater penetration or less penetration, the bucket tip may be rotated by 180 degrees.5. From the other side of the retainer, drive the pin through the bucket tip, through the adapter, and through the retainer.6. After you drive the pin, make sure that the retainer fits snugly into the pin groove.Side Cutters
Illustration 1201. Remove the mounting bolts and the side cutters.2. Clean the mounting surfaces. Some side cutters may be rotated for additional wear.3. Install the new side cutters or the rotated side cutters.