CONTROL GROUP 1121572 - Caterpillar

screen displays the PM3000 module when the module is part of the engine configuration."Miscellaneous Data Screen"
Illustration 5 g00750093
The "miscellaneous data screen" provides a summary of data on the system. The component data display has a color code that is assigned for alarm states:White - normal operationCyan - failure of a sensorYellow - alarmRed - shutdown"Maintenance Data Screen"
Illustration 6 g00750095
The "maintenance data screen" displays the following information:
Average exhaust port temperature
Manifold temperature of inlet air
Manifold pressure of inlet air
Temperature of turbine inlet
Temperature of turbine outlet
Fuel to filter pressure
Fuel to engine pressure
Differential in fuel pressure
Lube oil to filter pressure
Lube oil to engine pressure
Pressure differential in lube oil
Speed of turbines"Legend Screen"
Illustration 7 g00750102
The "legend screen" provides the definition for all of the symbols that are used in the panelview screens."Engine Configuration Screen"
Illustration 8 g00750103
Select the boxes that are based on the configuration of the engine. Press the boxes that are numeric in order to enter the rated speed and the cycles of the turbine."Auxilary Input Configuration Screen"
Illustration 9 g00750105
The "auxiliary input configuration screen" is used in order to configure the auxiliary alarms and auxiliary shutdowns. The analog alarms and shutdowns are enabled when the high configuration or the low configuration is selected. The following items are not updated until the save button is pressed:
Modified names
Units
Setpoints
ScalingThe high selections and the high setpoints are for the resistance temperature detectors and the 4-20 mA sensors. The low selections and low setpoints are for the resistance temperature detectors and the 4-20 mA sensors. Scaling is only for the 4-20 mA sensors."Programmable Output Configuration"
Illustration 10 g00750122
The "programmable output configuration" screen is used in order to program the outputs from the control panel. The arrow keys are used in order to select the analog value that should be displayed for each output. Refer to, "Alarms and Shutdowns" for more information on the alarms and shutdowns.The high limits and the low limits for the programmable speed controls can also be set by using the screen. The high limit and the low limit for the relays of the programmable speed control can be entered by selecting the numbered boxes. If the high limit is set below the low limit, the relay for speed control is energized when the engine is between the high speed range and the low speed range. If the high limit is set below the low limit, the relay for speed control is energized when the speed is outside of the range."Setpoint Screen"
Illustration 11 g00750130
Use the arrows in order to select the desired data. The items are read only. The screen shows the setpoints that are programmed in the program. The following items will be updated automatically:
Setpoints of Alarms
Delays of Alarms
Conditions of Alarms
Setpoints of Shutdowns
Delays of Shutdowns
Conditions of Shutdowns
Sensor Failure Delay"Modbus Configuration Screen"
Illustration 12 g00750140
The "modbus configuration screen" is used in order to change the port settings. The screen is an feature that is optional. Modify the settings of the port and press the save button in order to update the modbus communications. The following items are displayed on the screen:
"Address Port 1"
"RTS Off Delay"
"RTS