CONTROL GP-TRANSMISSION HYD 1230278 - Caterpillar

ROPS/FOPS Structure (2)This warning is located on the ROPS on the left side of the machine.
g00939192
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. This will void the certification. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
This machine has been certified to the standards that are listed on the film for the ROPS certification. The maximum mass of the machine, which includes the operator and the attachments without a payload, should not exceed the mass on the film for the ROPS certification.A typical example of the warning film and film for the ROPS certification are shown above.Refer to Operation and Maintenance Manual, "Guards (Operator Protection)" for more information.No Ether (3)This warning is located on the valve cover for the engine.
g01103503
If equipped with an air inlet heater (AIH) for cold weather starting, do not use aerosol types of starting aids such as ether. Such use could result in an explosion and personal injury.
Arm Crush (4)This warning is located near the side of each drum on both sides of the machine.
g01072820
Crush Hazard! Machine movement while making adjustments can cause injury or death.Shut off engine and remove key before making adjustments.Refer to the Operation and Maintenance Manual for the proper adjustment procedures.
Improper Connection Of Jump Start Cable (5)This warning is located on the cover plate of the battery compartment.
g01066454
Improper jumper cable connections can cause an explosion resulting in personal injury. Batteries can be located in separate compartments. When using jumper cable always connect positive (+) cable to positive (+) terminal of battery connected to starter solenoid and negative (−) cable from external source to starter negative (−) terminal. (If not equipped with starter negative terminal, connect to engine block.)
Improper connections of the battery cables may cause an explosion.Engine Coolant (6)This warning is located on top of the radiator.
g00782457
Pressurized System: Hot coolant can cause serious burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure.
No Clearance (7)This warning is located near the pivot area on both sides of the machine.
g00988060
No clearance for a man in this area when the machine turns. Severe injury or death from crushing could occur.Install the steering frame lock link into the locked position before lifting the machine, transporting the machine on another vehicle, or performing service near the center of the machine.Disengage the steering frame lock link from articulation joint and return to stored position before resuming operation or the machine will not steer.