CONTROL GP-ELECTRONIC 1246116 - Caterpillar

Dozer Blade Controls
Float (1) - Push the lever all the way forward into detent for dozer blade float. In this position, the dozer blade will move up and down following the ground contour.The lever will remain in the float position (detent) until manually pulled out of detent position. The lever will then return to HOLD. Lower (2) - Push the lever forward to lower the dozer blade. Release the lever and it will return to HOLD. Hold (3) - Release the lever from raise or lower, and it will return to HOLD. The dozer blade movement will stop. Raise (4) - Pull the lever back to raise the dozer blade. Release the lever and it will return to HOLD. Tilt Left (5) - Pull the lever to the left to lower the blade to the left. Release the lever and it will return to HOLD. Tilt Hold (6) - Release the lever and it will return to HOLD. The blade movement will stop. Tilt Right (7) - Push the lever to the right to lower the blade to the right. Release the lever and it will return to HOLD.Dozer Blade Angle (If Equipped)
Left Blade Angle (1) - Push the lever forward to angle the dozer blade to the left. Hold (2) - Release the lever and it will return. The dozer blade movement will stop. Right Blade Angle (3) - Pull the lever back to angle the dozer blade to the right.Ripper (If Equipped)
Raise (1) - Pull the lever to the left to raise the ripper. Release the lever and it will return to HOLD. Hold (2) - Release the lever and it will return. The ripper movement will stop. Lower (3) - Push the lever to the right to lower the ripper. Release the lever and it will return to HOLD.Winch Control Lever - Standard (If Equipped)
Brake Off-Disconnect (1) - Raise lock out ring (5) up to move into the disconnect. The lever will remain in this position until moved manually. The winch mechanism makes it possible to unreel the wire rope cable by hand. Brake Off-Release (2) - Move the lever to this position to RELEASE the wire rope cable. Release the lever and it will return to HOLD. The winch brake is released. The wire rope cable will unreel by the weight of the load, or when the machine moves away from load. Brake On-Hold (3) - Move the lever to this position and the wire rope cable will not move. Use this position when towing, holding load or when winch is not in use. Brake Off-Reel In (4) - Move the lever to this position to reel IN the wire rope cable. Release the lever and it will return to HOLD. The wire rope cable will move toward the winch under power.Winch Control Lever - Reel In or Out (If Equipped)
The lever (4) in the photo is used to determine if the winch is in the REEL IN or REEL OUT function. Reel In