CONTROL GP-MONITOR 1306427 - Caterpillar

Illustration 4 g06201198This plate is positioned on the bottom left side of the plate for the PIN.Note: The CE plate is on machines that are certified to the European Union requirements that were effective at that time.For machines compliant to 98/37/EC and 89/392/EEC, the following information is stamped onto the CE plate. For quick reference, record this information in the spaces that are provided below.
Engine Power Primary Engine (kW)____________________
Typical Machine Operating Weight for European Market (kg)____________________
Year____________________For manufacturer name and address and the country of origin, see the PIN plate.Eurasian Economic Union
For machines compliant to the Eurasian Economic Union requirements, the EAC mark plate is positioned near the Product Identification Number (PIN) plate (see Product Information Section of the machine Operation and Maintenance Manual). The EAC mark plate is placed on machines certified to the Eurasian Economic Union requirements effective at the time of market entry.
Illustration 5 g06094564The Month and Year of Manufacture are on the PIN plate.Manufacturer Information
Manufacturer:Caterpillar Inc.,
100 N.E. Adams Street
Peoria, Illinois 61629, USA
Entity authorized by the manufacturer at the territory of Eurasian Economic Union:Caterpillar Eurasia LLC
75, Sadovnicheskaya Emb.
Moscow 115035, Russia
Serial Number Plates (SN)
Engine Serial Number
Illustration 6 g03485740The engine serial number plate is on the left side of the engine.Transmission Serial Number
Illustration 7 g03726398The transmission serial number is on the left side of the transmission.Transfer Gear Serial Number
Illustration 8 g03775217The transfer gear serial number is on the left side of the transfer gear.Suspension Cylinder Strut
The following information is stamped onto the suspension cylinder:
ACC. 447-2272 EC00
CAT HYD. ITALY
SN: XXXXXXXXX
YEAR: XXXX
V: 3.92L
PS: 247BAR
PT: 353 BAR
TS: -40C 50C
TEST DATE: XXXXXX
CE 0948Note: Make sure that all the information is legible. Clean the information if you cannot read the words.Certification
ROPS/FOPS Plate
These films are located inside the cab.
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
Illustration 9 g06195654This machine has been certified to the standards that are listed on the certification plate. The maximum mass of the machine, which includes the operator and the attachments without a payload, should not exceed the mass on the certification plate.Electromagnetic Emissions
Note: This label is on machines that are going into Canada.
Illustration 10 g06063443If equipped, this label is located next to the Pin plate. This label verifies that the product meets the requirements of ICES-002 Issue 6. Compliance to ICES-002 Issue 6 is accomplished by meeting electromagnetic emissions industry standard CISPR-12.Sound
Illustration 11 g00933634
A typical example of this film is shown. Your machine may have a different value.
If equipped, the certification film is used to verify the environmental sound certification of the machine to the requirements of the European Union. The value that is listed on the film indicates the guaranteed exterior sound power level LWA at the time of manufacture for the conditions that are specified in "ISO 6395" and "EU 2000/14/EC Annex III A2.1b".