CONTROL GP- 1318664 - Caterpillar

Start By:
Remove the exhaust elbow.
Illustration 1 g02177953
Remove two bolts (5) .
Remove bolts (1) and plate assembly (2) .
Remove bolts (4) and plate assembly (3) .
Illustration 2 g02183993
Remove bolts (6) and plate assembly (7) .
Illustration 3 g02198756
Remove bolts (8) and guard assembly (9) .
Illustration 4 g02145957
Note: Check hose (10) for wear or damage. Replace the hose, if necessary.
Disconnect hose (10) .
Loosen clamp (11) and reposition shroud seal (12)
Illustration 5 g02146015
Note: Check hose (13) for wear or damage. Replace the hose, if necessary.
Disconnect hose (13) .
Illustration 6 g02146120
Disconnect clamps (14) and (15) .
Illustration 7 g02146142
Disconnect clamps (16) and (17) .
Illustration 8 g02146158
Disconnect clamps (20), (21), and (22). Disconnect ground strap (18) and bracket (19) .
Illustration 9 g02200735
Disconnect clamps (23) .
Illustration 10 g02713329
Disconnect clamp (24) .
Illustration 11 g02713324
Loosen bolts (25). Repeat for the opposite side.
Illustration 12 g02200737
Illustration 13 g02713312
Attach a suitable lifting device to engine (26) to support the front of the engine. The approximate weight of engine (26) is approximately 862 kg (1900 lb).
Remove bolt (25) and washer (28). Repeat for the opposite side.
Raise engine (26) high enough to remove engine front mounts (29) .Installation Procedure
Install engine front mounts (29) in the reverse order of removal.
Tighten bolts (25) to a torque of 520 70 N m (384 52 lb ft).
Tighten clamp (11) to a torque of 4 1 N m (35 9 lb in).
Apply Tooling (A) to the threads of bolts (1), (4), (5), and (6) .