CONTROL GP-ELECTRONIC 1363085 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7575 Link Bracket 1
B 1P-0520 Driver Group 1
C 230-6262 Sealant 1 Start By:
Remove the rear gears.
Illustration 1 g02749164
Illustration 2 g02749166
Remove plug (1) and disconnect hose assembly (2).
Attach Tooling (A) to Location (X). The weight of rear housing (3) is 84 kg (185 lb).
Remove bolts (4) and remove rear housing (3).
Illustration 3 g02749117
Remove gasket (5).
Remove dowels (6). Remove bearing sleeve (7) and the dowels. Installation Procedure
Install rear housing (3) in the reverse order of removal. Note: Make sure that the housing and the face of the block are free of contaminants prior to installation.Note: Apply clean engine oil to the bearings and the shaft assemblies prior to installation on the engine.
Use Tooling (B) to install bearing sleeve (25).
Illustration 4 g02749119
Install gasket (23). Apply a continuous bead of Tooling (C) to Areas (Y). The sealant should span the entire width of the T-Joint .
Illustration 5 g02749137
Attach Tooling (B) to Location (X). The weight of rear housing (21) is 84 kg (185 lb).
Position rear housing (3). Install bolts (4). Tighten bolts (4) to a torque of 55 10 N m (41 7 lb ft) using the sequence in Illustration 5.