CONTROL 1411797 - Caterpillar

Illustration 11 g03516179
Connect to the "Service Dashboard". Under the Product Link drop down, select "Config File Upload". Refer to Illustration 11.Note: Older versions of the PLE601 Network Manager Software, required the technician to type in the full URL of the "Config Upload" page. Flash the PLE601 Network Manager with the latest software, and load the configuration file through the "Service Dashboard" button.
Choose the "Browse" button to upload the configuration file that is already stored on your computer.
Select the "Upload" button to upload the configuration file.Note: The Network Manager will need to power cycle before the configuration file part number is displayed in the "Product Link Interface".Required Application to Connect to the PLE601 EPA Datalogger
Prior to connecting to the PLE601 EPA Datalogger, download the Cat ECM finder application. This software is required to access the codes from the PLE601 EPA Datalogger.
Go to https://dealer.cat.com/PL/Toolbox, under the required software section, download the Cat ECM Finder application (standalone version).The "Web Configuration" home page is accessed by attaching the 425-6889 Cable As to the PLE601 harness, and a laptop. Once a connection is made, the user can use the following Steps to access the "Web Configuration" home page. There are two ways to connect to the "Web Configuration" home page, the first is through the "Browse Network Devices" option in 2014C or newer Cat ET.Connect to the PLE601 EPA Datalogger
The "Web Configuration" home page is accessed by attaching the 425-6889 Cable As to the PLE601 harness and a laptop. Once a connection is made, the user can use the following steps to access the "Web Configuration" home page.
Connect to the Product Link device with the 425-6889 Cable As.
Open the Cat ECM Finder application
Illustration 12 g06028302
In the "Network Devices" drop-down menu, select your laptop’s wired Ethernet port. This selection may vary based on the operating system and laptop.
Once the ECMs are detected, select an ECM and then click the "Launch" button. This will launch the "Web Configuration" home page into your preferred network browser.
Illustration 13 g06128725
Click "Product Link" to get to the Product Link Interface.The "Product Link Interface" page supplies basic system information about PLE601 Network Manager device installed.
Illustration 14 g06128727
Click "EPA Logger" to navigate to the EPA Datalogger tab.User will be prompted to retrieve EPA Information. Select "Yes" to view the information.
Illustration 15 g06128728The EPA logger tab will display the reporting ECM address, Diagnostic and Failure Mode Identifier, ECM Source Address and the date the diagnostic was active.In the EPA Logger page, the user may download the displayed information by clicking the "Download" button.The PLE601 EPA Datalogger will store six codes required by EPA for one year. The codes and their descriptions are listed in Table 8.
Table 8
CDL-WCI SPN-FMI SPN Description
2348-9 1231-9 J1939 Network 1 Abnormal Update Rate
1040-2 3360-31 Aftertreatment 1 Diesel Exhaust Fluid Controller
1607-2 7417-2 Aftertreatment 1 Diesel Exhaust Fluid Controller Circuit Breaker: Erratic, Intermittent, or Incorrect
1364-2 3516-18 Aftertreatment 1 Diesel Exhaust Fluid Concentration (Low - Moderate Severity)
946-2 4360-16 Aftertreatment 1 SCR Catalyst Intake Gas Temperature (High - Moderate Severity)
955-3 4367-1 Aftertreatment 1 Diesel Exhaust Fluid Thaw