CONTROL GP-UNPROGRAMMED 1566155 - Caterpillar

Remove Junction Box
1. Disconnect wiring harnesses (1) from the tachometer and service meter drive. 2. Disconnect wiring harness (2) from the shutoff solenoid on the air intake housing. 3. Disconnect wiring harness (3) from the shutdown solenoid on the governor. 4. Disconnect wiring harness (4) from the water temperature contactor. 5. Remove the screws from panel (5), and lower the panel to a horizontal position. Fasten panel (5) to box assembly (6) with wire to hold the panel in the horizontal position. 6. Disconnect wires (7) from the tachometer, and remove the wires from the panel. 7. Disconnect wiring harness (8) from the engine shutdown switch. 8. Disconnect strap assembly (9) from water line (11). Disconnect hose assembly (10) from the junction box. 9. Remove the three mounting nuts from junction box (12), and remove junction box (12) from the engine.Install Junction Box
1. Put junction box (1) in position on its mounting brackets, and install the three mounting nuts to hold the junction box in position.2. Connect hose assembly (2) to the junction box, and connect strap assembly (4) to water line (3). 3. Connect wiring harness (5) to the engine shutdown switch. 4. Install wires (6) on panel (7), and connect wires (6) to the tachometer. 5. Remove the wire that holds panel (7) in its horizontal position, and put the panel back in its original position in box assembly (8). Install the screws that hold the panel in the box assembly. 6. Connect wiring harness (9) to the water temperature contactor. 7. Connect wiring harness (10) to the shutdown solenoid on the governor. 8. Connect wiring harness (11) to the shutoff solenoid on the air intake housing. 9. Connect wiring harness (12) to the tachometer and service meter drive.