CONTROL GP-TRANSMISSION 1667820 - Caterpillar

Turn Signal/Hazard Switch
Turn Signal - Move the lever UP (1) for a RIGHT turn. Move lever to the center (2) to turn off the lights. Move the lever DOWN (3) for a LEFT turn. Hazard - Pull the handle OUT to turn the hazard lights on. Push the handle IN to turn the lights off.Starting Aid
Starting Aid Switch - Used in cold weather to inject starting fluid (ether) into the intake manifold. Push knob while cranking the engine to inject a metered amount of starting fluid.Fuel Pump Switch
Fuel Pump Switch - Move the switch UP to activate the electric fuel pump. Release the switch and it will return to the off position.Use this switch to aid in starting, before or while cranking the engine. Use this switch to fill fuel lines after changing fuel filters, after performing maintenance on the fuel system or if the machine has run out of fuel.Windshield Washer/Wiper
Windshield Wiper - Turn the switch to the right to the first position for slow wiper speed. Turn the switch further to the right, to the second position for fast wiper speed. Turn the switch to the left to stop the wipers. Windshield Washer - Push the knob to activate the windshield washer. The switch goes back to OFF when released.Horn
Horn - Push the switch down to sound the horn. Release to stop. Use the horn to signal or alert people nearby.Interior Dome Light
Dome Light - Move the switch to turn the inside cab light on or off.Heating and Air Conditioning Operation
In dusty conditions, keep the windows closed and use the air conditioner. Fan Switch - This switch (1) controls the three speed blower fan motor. Heating Control-OFF - Turn knob (2) all the way to the LEFT (counterclockwise). Warm - Turn knob (2) to the RIGHT (clockwise), with the fan switch in the HIGH(III), MEDIUM(II) or LOW(I) heat position, until the desired amount of heating is achieved.The knob can be set at any position to obtain the desired amount of heating. Air Conditioning Control-OFF - Turn knob (3) all the way to the left (counterclockwise). Cool - Turn knob (3) to the RIGHT (clockwise), with the fan switch in the LOW,(I) MEDIUM(II) or HIGH(III) cool position, until the desired amount of cooling is achieved.The knob can be set at any position to obtain the desired amount of cooling. Pressurizing - Pressurizing provides a clean atmosphere for the operator when heating or cooling is not required. Turn the heating and air conditioning controls to OFF. Turn the fan control knob to the RIGHT (clockwise) to either LOW, MEDIUM or HIGH speed, as needed to keep out dust.Access and Exit Procedures
Access
For access to the operator's compartment, use the