CONTROL GP- 1696347 - Caterpillar

Introduction
Do not perform any procedure in this Special Instruction until you have read the information and you understand the information.This Special Instruction provides installation procedure of new software for VIMS module on certain Motor Graders.Important Safety Information
Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard.Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. Ensure that any tool, procedure, work method, or operating technique you use that is not recommended by Caterpillar is safe.Ensure that the product will not be damaged or the product will not be made unsafe by the operation, lubrication, maintenance, or repair procedures used.
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Cat dealer for replacement manuals. Proper care is your responsibility.
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.Prevent possible injury by performing the procedure that follows before working on the machine.Move the machine to a smooth and level location that is away from working machines and personnel.Engage the parking brake. Stop the engine.To avoid accidental engine starting, turn the battery disconnect switch to the OFF position. Remove the key for the battery disconnect switch. Use a secure padlock in order to lock the battery compartment access door.Place a "Do Not Operate" tag at the Start/Stop switch location to inform personnel that the equipment is being worked on.
Installation Procedure
Perform the following procedure to install the new software files:
Before flashing the software, obtain Cat ® Electronic Technician (Cat ET) 2014C or later and Communication Adapter 3, VIMSpc 2013A or later, MineStar configuration files if applicable (GPS and geotransformfiles).
Download VIMS settings/information to help you reconfigure VIMS.
Connect to VIMS Main when prompted.
Using Cat ET, download Cat ET>Information>Product Status Report (F6).
Record VIMS settings using VIMSpc, under Communicator pages (Auto File Download, Automatic Schedule Settings, and Settings).
Under XIM record the MineStar Configuration.
Illustration 1 g06008912
This software requires for the CAN wires to be swapped as shown in the Illustration ***#i06642904/i06523840.10***. If the wires match what is shown in the Illustration ***#i06642904/i06523840.10***, switch wires 33 to 34 and 41 to 50.
Using Cat ET>Winflash, proceed to flash 461-9131 Monitor Software Gp cycle power (off 60 seconds).
After flashing. Connect to Cat ET.Note: