CONTROL GP-MONITOR 1720062 - Caterpillar

Machine Preparation
Clear all personnel from the machine and from the area around the machine.
Start the engine.
Illustration 2 g02449876
Engine speed dial
Set the engine speed dial at "10".
Lower the left console.
Position the machine on level ground. Check the visibility and adjust the mirrors for the best vision close to the machine.
Lower the stabilizers and the blade tip.
Increase the hydraulic oil temperature to 46° to 60° C (115° to 140° F).
Fully extend the bucket cylinder and place the bucket on the ground.
Stop the engine.
Release the pressure in the hydraulic system.Note: Refer to Testing and Adjusting, "System Pressure - Release".
Raise the left console.
Illustration 3 g03792823
Pressure taps are located behind the left front access door
Connect tooling (B1) 4,000 kPa (580 psi) pressure sensor to the pilot pressure tap.Test Procedure
Start the engine.
Illustration 4 g02452604
Engine speed dial
Set the engine speed dial at "1".
Illustration 5 g02446738
Power mode control button on the soft panel switch
Push down on the power mode control button to activate power mode.Note: The indicator light will be illuminated when power mode is activated.
Lower the left console.
Illustration 6 g02447036
Automatic Engine Speed Control (AESC) as displayed on the programmable function key in the monitor.
Disable the automatic engine speed control through the monitor by pressing the programmable button.
Illustration 7 g03722432
Hydraulic modulation switch on left joystick
Illustration 8 g06174873
Hydraulic modulation medium mode (monitor display)
Select the hydraulic modulation mode as medium. Press the lower front switch on the left joystick to select the hydraulic modulation mode.
The air conditioning should be turned off for the following test.
Check the pressure at the pilot pressure tap. Refer to Table 1 for the correct pressure.
If the pilot relief pressure is not correct, proceed to the "Adjust Procedure".Adjust Procedure
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.
Illustration 9 g03792809
Pilot manifold
(1) Pilot relief valve
(2) Locknut
(3) Adjustment screw
Loosen locknut (2) on pilot relief valve (1).
Turn adjustment screw (3) on pilot relief valve (1) clockwise to increase the pilot relief pressure. Turn adjustment screw (3) on pilot relief valve (1) counter clockwise to decrease the pilot relief pressure.Note: The pressure will increase by approximately 250 kPa (36 psi) when the adjustment screw is turned by 1 turn.Note: Make the final pressure adjustments on the pressure rise.
Check the pressure at the pilot pressure tap. Refer to Table 1 for the correct pressure
Repeat the "Adjust Procedure", until the pilot relief pressure has been met.
While adjustment screw (3) is being held, tighten locknut (2) to the specified torque.