CONTROL GP-ENG RATINGS ELEK 1851395 - Caterpillar

Introduction
This Special Instruction provides the information that is necessary to install Service Parts for the seat.Service Parts
Illustration 1 g00799776
Service parts are now available for the 119-1784 Seat . Two possible seat assemblies were available in the suspension seat group. Match the pattern on your seat to the pattern that is shown in illustration 1. The pattern will determine the correct service parts for your seat.Use the appropriate section of this Special Instruction for removal and installation of your seat kits.The following service parts kits are available for the Seat (A).
Table 1
Service Parts Kit for Seat A    
Quantity     Part Number     Description    
1     195-8776     LH Arm    
1     195-8777     RH Arm    The following service part arms are available for Seat (B).
Table 2
Service Parts Kit for Seat B    
Quantity     Part Number     Description    
1     195-8778     LH Arm    
1     195-8779     RH Arm    Procedure For The Installation Of The Arm On Seat "A" And The Procedure To Remove The Arm On Seat "A"
Service parts for seat (A) include the following items:
Table 3
Service Parts Kit    
Quantity     Description    
1     Right Hand or Left Hand Armrest (1)    
1     Arm Adjuster Bracket Right Hand or Left Hand (2)    
1     Adjustment Screw (3)    
1     Bushing (4)    
1     Plastic Washer (5)    
1     Spring Washer (6)    
1     1 3/4 inch Screw (7)    
1     1 inch Screw (8)    
1     Spacer (9)    
1     Arm Plate (10)    
Illustration 2 g00799778
Note: Use the same procedure for the left hand arm and for the right hand arm.
Check the side of the back cushion in order to locate arm plate (10) .
Locate the larger hole in the arm plate. Use scissors in order to cut a hole through the material. Cut the material until you reach a smaller hole. The smaller hole is approximately 1 inch downward from the larger hole. Cut a small piece of fabric from each hole. Assemble the arm adjuster bracket (2) over the holes in arm plate (10). Draw a line around arm adjuster bracket (2). Cut along the line.
Install a 1 3/4 inch screw (7). Assemble