CONTROL AS- 1856779 - Caterpillar

Illustration 3 g01039749
Install hub plate (13). The alignment hole (20) must be aligned with Alignment Mark (Y).
Illustration 4 g01039753
Use two people and install spacer (12). The weight of the spacer is approximately 29 kg (65 lb). The alignment hole (21) must be aligned with Alignment Mark (Y). Note: Install Tooling (D) in order to ensure correct alignment. Tooling (D) must be aligned with Alignment Mark (Y). The Alignment Mark (X) on the spacer must face upward.
Remove Tooling (D).
Illustration 5 g01039804
Install new springs (11). The right side end of the spring must face the center of Tooling (A). The right side end of the spring must face upward. Note: The orientation of the spring should provide maximum contact with the hub plate.Note: Do not reuse the old springs.
Illustration 6 g01039805
Install spring cage (10). The tabs (23) on the spring cage must face upward. Note: Install Tooling (D) in alignment hole (22) in order to ensure correct alignment. Tooling (D) must be aligned with Alignment Mark (Y).
Remove Tooling (D).
Illustration 7 g01039844
Install hub barrel (9). The timing mark (24) on the hub barrel must be aligned with the Timing Mark (Z) on Tooling (A).
Illustration 8 g01039830
Use two people and install spacer (8). The weight of the spacer is approximately 29 kg (65 lb). The alignment hole (25) must be aligned with Alignment Mark (Y). The Alignment Mark (X) on the spacer must face upward. Note: Install Tooling (D) and Tooling (E) in order to ensure correct alignment. Tooling (D) and Tooling (E) must be aligned with Alignment Mark (Y).
Remove Tooling (D) and Tooling (E).
Illustration 9 g01039812
Install spring cage (7). The tabs (27) on the spring cage must face downward. The alignment hole (26) must be aligned with Alignment Mark (Y). Note: Install Tooling (D) in order to ensure correct alignment. Tooling (D) must be aligned with Alignment Mark (Y).
Remove Tooling (D).
Illustration 10 g01039855
Install hub plate (6). The alignment hole (28) must be aligned with Alignment Mark (Y).
Illustration 11 g01039882
Use two people and install spacer (4). The weight of the spacer is approximately 29 kg (65 lb). The alignment hole (29) on the spacer must be aligned with Alignment Mark (Y). The Alignment Mark (X) on the spacer must face upward. Note: Install Tooling (D) and Tooling (E) in order to ensure correct alignment. Tooling (D) and Tooling (E) must be aligned with Alignment Mark (Y).
Remove Tooling (D).
Illustration 12 g01039884
Install new springs (3). The right side end of the spring must face the hub barrel (9). The right side end of the spring must face upward. Note: The orientation of the spring should provide maximum contact with the hub plate.Note: Do not reuse the old springs.
Remove Tooling (E).
Illustration 13 g01039885
Install spring cage (2). The tabs (27) on the spring cage must face upward. The alignment hole (25) on the spacer must be aligned with Alignment Mark (Y ). Note: Install Tooling (D) and Tooling (E) in order to ensure correct alignment. Tooling (D) and Tooling (E) must be aligned with Alignment Mark (Y).
Install bolts (1) and bolts (5). Tighten the bolts to a